REV COUNT
DESCRIPTION OF REVISIONS
BY
CHKD DATE
REV COUNT DESCRIPTION OF REVISIONS
BY
CHKD DATE
REVISED
REVISED
JS.PARK HJ.LEE 16.08.03
JS.PARK HJ.LEE 16.10.12
REVISED
JS.PARK HJ.KIM 16.12.07
-
-
2
4
REVISED
HJ.KIM
HJ.LEE 17.10.13
-
2
3
5
USB Type-C Cable and Connector Specification Release 1.2
USB Type-C Connector and Cable Assemblies Compliance Document Revision 1.0
APPLICABLE STANDARD
DC 1.25A max. for each power pin (i.e. A1, A4, A9, A12, B1, B4, B5, B9, B12)
DC 0.25A for the other pins
CURRENT
5
RATING
VOLTAGE
20VAC
OPERATING CONDITION
STORAGE CONDITION
-30℃ ~ +85℃(INCLUDING TEMP. RISE), 95% RH MAX.(NON-CONDENSING)
-10℃ ~ +60℃(WITH PACKING), 15% ~ 70% RH
Para.
1
Test Description
Test Procedure
Test Requirement
No physical damage
QT AT
O O
EIA 364-18
Visual inspection
Examination of product
Electrical Requirements
EIA 364-23
Measure at 20mV max open circuit at 100mA(DC
OR 1000Hz).
4-wire measurement is required and the
resistance of PCB termination shall be deducted
from the reading.
40mΩ max initial for each contact.
50mΩ max after initial measurement.
2
Low Level Contact Resistance
O
-
EIA 364-20
Measure per Method B with unmated condition.
100VAC RMS for 1 minute at sea level.
Dielectric
Withstanding Voltage
3
4
No distruptive discharge.
100MΩ Min.
O
O
-
-
EIA 364-21
500VDC with unmated and mated condition.
Insulation Resistance
Mechanical Requirements
EIA 364-13
Measure at 12.5mm/minute min.
5
Insertion force
5N to 20N
O
O
-
-
EIA 364-13
Measure at 12.5mm/minute min.
Initial : 8N to 20N
After test : 6N to 20N
6
Extraction force
Low level contact resistance and
dielectric withstanding voltage shall
meet the spec after test.
EIA 364-09
10,000 insertion/extration cycles
Cycle rate : 500±50 cycles per hour.
7
Durability
Vibration
O
O
-
-
EIA 364-28
No physical damage and no
discontinuity longer than 1us.
Low level contact resistance meets
spec before and after the test.
Test Condition VII, Test Letter D
20-500 Hz random levels, 15minutes in
each of 3 mutually perpendicular directions.
8
REMARKS
DRAFT
DESIGN
CHECK
APPROVAL
RELEASE
DEPT
17.10.13
ENG
HIROSE will not guarantee the performance on
these specifications in case this product will be
mated with the others which is not HIROSE's
JS.PARK
16.08.03
JS.PARK
16.08.03
HJ.LEE
TS.KANG
16.08.03
16.08.03
5
NOTE) QT : QUALIFICATION TEST, AT : ASSURANCE TEST, O: Applicable Test
DWG NO CL NO
PART NO
CX60-24S-UNIT
ELC4-631979
HIROSE KOREA.CO.,LTD
CL 6240-0001-9
1
PRODUCT SPECIFICATION
3