CDP8
Description
Constant-Duty Power Supply
The Gamewell-FCI CDP8 Constant-Duty Power Supply is
a regulated, power-limited, 24 VDC, 8.0 amp. power supply
which can be used anywhere a constant 24 VDC source is
required. The CDP8 is suited and UL-Listed for fire alarm,
access control, and general power supply applications.
The Gamewell-FCI CDP8 provides four (4) power-limited,
24 VDC, 3.0 amp. outputs. Each output can be individually
configured to shed its load (turn off) during a power failure
to extend available standby battery power for designated
critical circuits.
Each output circuit is monitored for overload or shorted
conditions, with the trouble condition indicated by a specific
circuit trouble LED and activation of the common trouble
relay. Overloaded circuits will automatically restore when
the overload is removed.
CDP8
Engineer’s Specifications
The power supply shall provide four (4) output circuits
capable of up to 3.0 amp. continuous 24 VDC each to a
maximum of 8.0 amps. total. The output voltage shall be
regulated and power-limited. Each output circuit shall be
configurable to shed its load with the loss of the primary AC
source. The Constant-Duty Power Supply shall include an
internal battery charger with charging capacity of 26 AH. It
shall also be operational from an externally charged bat-
tery. Operational troubles shall be indicated by seven LEDs
and a common trouble Form-C relay. The supply shall also
have a delayed AC Fail relay. The Constant-Duty Power
Supply shall be Gamewell-FCI, model CDP8.
Features
•
•
Four (4) configurable monitored outputs
8.0 A, 24 VDC, fully regulated full-load output
(power-limited)
•
•
•
•
•
•
•
•
•
Seven (7) trouble and status LEDs
Common trouble Form-C relay
Isolated AC Fail Form-C relay
Selectable AC Fail notification relay
Ground fault detection
26.0 A battery-charger capability
Selectable internal battery charger disable
Selectable internal ground fault detection disable
Selectable load shedding on AC Fail per output
Specifications
Primary Input Power: 120 VAC, 50/60 Hz, 3.5 A
or 220 V, 1.9 A, jumper-selectable.
Secondary Power:
Battery Charging
Capacity:
24-volt: two 7 – 26 AH batteries
Up to 26 AH batteries
Total Output Power: 8.0 A maximum
Standby Current:
Output Ratings:
0.03 A
24 VDC fully regulated, 3.0 A max-
imum per circuit, 8.0 A total
An ISO 9000-2000 Company
Cabinet Dimensions: 18.0" H x 12.5" W x 4.5" D
SIGNALING
(45.72 H x 31.75 W x 11.43 D cm)
S8240 7315-1288:163
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118
Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.
©2007 by Honeywell International Inc. All rights reserved.
www.gamewell-fci.com
CS-2283 Rev. a page 1 of 2