E
CAT5111
100-Tap Digitally Programmable Potentiometer (DPP™)
with Buffered Wiper
TM
FEATURES
APPLICATIONS
■ 100-position linear taper potentiometer
■ Automated product calibration
■ Remote control adjustments
■ Offset, gain and zero control
■ Tamper-proof calibrations
■ Non-volatile NVRAM wiper storage;
buffered wiper
■ Low power CMOS technology
■ Single supply operation: 2.5V-6.0V
■ Increment up/down serial interface
■ Resistance values: 10kΩ, 50kΩ and 100kΩ
■ Available in PDIP, SOIC, TSSOP and MSOP packages
■ Contrast, brightness and volume controls
■ Motor controls and feedback systems
■ Programmable analog functions
DESCRIPTION
system values without effecting the stored
setting. Wiper-control of the CAT5111 is
accomplished with three input control pins, CS, U/D,
and INC. The INC input increments the wiper in the
direction which is determined by the logic state of
the U/D input. The CS input is used to select the
device and also store the wiper position prior to
power down.
The CAT5111 is a single digitally programmable
potentiometer (DPP™) designed as a electronic
replacement for mechanical potentiometers and trim
pots. Ideal for automated adjustments on high volume
production lines, they are also well suited for
applications where equipment requiring periodic
adjustment is either difficult to access or located in a
hazardous or remote environment.
The digitally programmable potentiometer can be
used as a buffered voltage divider. For applications
wherethepotentiometerisusedasa2-terminalvariable
resistor, please refer to the CAT5113. The buffered
wiper of the CAT5111 is not compatible with that
application. DPPs bring variability and programmability
to a broad range of applications and are used primarily
tocontrol,regulateoradjustacharacteristicorparameter
of an analog circuit.
The CAT5111 contains a 100-tap series resistor array
connected between two terminals RH and RL. An up/
down counter and decoder that are controlled by three
input pins, determines which tap is connected to the
wiper, RWB. The CAT5111 wiper is buffered by an op
amp that operates rail to rail. The wiper setting, stored in
non-volatileNVRAMmemory,isnotlostwhenthedevice
is powered down and is automatically recalled when
powerisreturned. Thewipercanbeadjustedtotestnew
FUNCTIONAL DIAGRAM
R
H
V
CC
R
H
U/D
+
–
R
Control
and
Memory
WB
+
-
INC
CS
R
R
WB
L
Power On Recall
R
L
Electronic Potentiometer
Implementation
GND
© 2004 by Catalyst Semiconductor, Inc.
Characteristics subject to change without notice
1
Doc. No. 2008, Rev. O