5秒后页面跳转
BRCL4054ME PDF预览

BRCL4054ME

更新时间: 2024-11-21 17:15:19
品牌 Logo 应用领域
蓝箭 - FOSHAN /
页数 文件大小 规格书
25页 2723K
描述
SOT23-5

BRCL4054ME 数据手册

 浏览型号BRCL4054ME的Datasheet PDF文件第2页浏览型号BRCL4054ME的Datasheet PDF文件第3页浏览型号BRCL4054ME的Datasheet PDF文件第4页浏览型号BRCL4054ME的Datasheet PDF文件第5页浏览型号BRCL4054ME的Datasheet PDF文件第6页浏览型号BRCL4054ME的Datasheet PDF文件第7页 
BRCL4054ME  
Rev.F Apr.-2020  
DATA SHEET  
描述 / Descriptions  
BRCL4054ME是一款完整的单节锂离子电池采用恒定电流/恒定电压线性充电器。其SOT封装与较少  
的外部元件数目使得BRCL4054ME成为便携式应用的理想选择。BRCL4054ME可以适合USB电源和适  
配器电源工作。  
The BRCL4054ME is a complete constant-current/constant voltage linear charger for single cell  
lithium-ion batteries. Its ThinSOT package and low external component count make the  
BRCL4054ME ideally suited for portable applications. Furthermore, the BRCL4054ME is specifically  
designed to work within USB power specifications.  
由于采用了内部PMOSFET架构,加上防倒充电路,所以不需要外部检测电阻器和隔离二极管。热反  
馈可对充电电流进行调节便在大功率操作或高环境温度条件下对芯片温度加以限制电电压固定  
于4.2V,而充电电流可通过一个电阻器进行外部设置当充电电流在达到最终浮充电压之后降至设定值  
1/10时,BRCL4054ME将自动终止充电循环。  
No external sense resistor is needed, and no blocking diode is required due to the internal  
MOSFET architecture. Thermal feedback regulates the charge current to limit the die temperature  
during high power operation or high ambient temperature. The charge voltage is fixed at 4.2V, and the  
charge current can be programmed externally with a single resistor. The BRCL4054ME automatically  
terminates the charge cycle when the charge current drops to 1/10th the programmed value after the  
final float voltage is reached.  
当输入电压(交流适配器或USB电源)被拿掉时,BRCL4054ME自动进入一个低电流状态,将电池  
漏电流降至2uA以下。也可将BRCL4054ME置于停机模式,以而将供电电流降至25uA。  
BRCL4054ME的其他特点包括充电电流监控器、欠压闭锁、自动再充电和一个用于指示充电结束和输  
入电压接入的状态引脚。  
When the input supply (wall adapter or USB supply) is removed, the BRCL4054ME automatically  
enters a low current state, dropping the battery drain current to less than 2μA. The BRCL4054ME can  
be put into shutdown mode, reducing the supply current to 25μA. Other features include charge  
current monitor, under voltage lockout, automatic recharge and a status pin to indicate charge  
termination and the presence of an input voltage.  
特征 / Features  
¾
高达800mA的可编程充电电流  
Programmable Charge Current Up to 800mA  
¾
无需MOSFET、检测电阻器或隔离二极管  
No MOSFET, Sense Resistor or Blocking Diode Required  
用于单节锂离子电池、采用SOT23-5封装的完整线性充电器  
Complete Linear Charger in 5-Lead SOT-23 Package for Single Cell Lithium-Ion Batteries  
恒定电流/恒定电压操作,并具有热调节功能  
¾
¾
¾
Constant-Current/Constant-Voltage Operation with Thermal Regulation to Maximize Charge Rate  
Without Risk of Overheating  
¾
¾
¾
¾
直接从USB端口给单节锂离子电池充电  
Charges Single Cell Li-Ion Batteries Directly from USB Port  
4.2V预设充电电压  
Preset 4.2V Charge Voltage with ±1% Accuracy  
用于电池电量检测的充电电流监控器输出  
Charge Current Monitor Output for Gas Gauging  
自动再充电  
Automatic Recharge  
http://www.fsbrec.com  
1 / 25