捷配首页

Datasheet > 电源电路 > 电源管理电路> BQ77PL900DL
BQ77PL900DL PDF预览

BQ77PL900DL

更新时间： 2025-07-22 03:22:27
品牌 Logo 应用领域
德州仪器 - TI 电源电路电池电源管理电路光电二极管PC
页数 文件大小 规格书
57页 748K
描述
Five to Ten Series Cell Lithium-Ion or Lithium-Polymer Battery Protector and Analog Front End

阅读下载

中文翻译

获取价格

BQ77PL900DL 技术参数

是否无铅：不含铅是否Rohs认证：符合
生命周期：Active零件包装代码：SSOP
包装说明：SSOP-48针数：48
Reach Compliance Code：compliantECCN代码：EAR99
HTS代码：8542.39.00.01Factory Lead Time：1 week
风险等级：0.79Samacsys Confidence：3
Samacsys Status：ReleasedSamacsys PartID：229664
Samacsys Pin Count：48Samacsys Part Category：Integrated Circuit
Samacsys Package Category：Small Outline PackagesSamacsys Footprint Name：DL (R-PDSO-G48)
Samacsys Released Date：2015-07-18 19:24:53Is Samacsys：N
可调阈值：YES模拟集成电路 - 其他类型：POWER SUPPLY MANAGEMENT CIRCUIT
JESD-30 代码：R-PDSO-G48JESD-609代码：e4
长度：15.88 mm湿度敏感等级：2
信道数量：10功能数量：1
端子数量：48最高工作温度：100 °C
最低工作温度：-40 °C封装主体材料：PLASTIC/EPOXY
封装代码：SSOP封装等效代码：SSOP48,.4
封装形状：RECTANGULAR封装形式：SMALL OUTLINE, SHRINK PITCH
峰值回流温度（摄氏度）：260电源：7/50 V
认证状态：Not Qualified座面最大高度：2.59 mm
子类别：Power Management Circuits最大供电电流 (Isup)：0.8 mA
最大供电电压 (Vsup)：50 V最小供电电压 (Vsup)：7 V
标称供电电压 (Vsup)：36 V表面贴装：YES
温度等级：INDUSTRIAL端子面层：Nickel/Palladium/Gold (Ni/Pd/Au)
端子形式：GULL WING端子节距：0.635 mm
端子位置：DUAL处于峰值回流温度下的最长时间：NOT SPECIFIED
宽度：7.49 mmBase Number Matches：1

BQ77PL900DL 数据手册

 浏览型号BQ77PL900DL的Datasheet PDF文件第2页浏览型号BQ77PL900DL的Datasheet PDF文件第3页浏览型号BQ77PL900DL的Datasheet PDF文件第4页浏览型号BQ77PL900DL的Datasheet PDF文件第5页浏览型号BQ77PL900DL的Datasheet PDF文件第6页浏览型号BQ77PL900DL的Datasheet PDF文件第7页 
bq77PL900  
www.ti.com ...................................................................................................................................................................................................... SLUS844–JUNE 2008  
Five to Ten Series Cell Lithium-Ion or Lithium-Polymer Battery Protector  
and Analog Front End  
1
FEATURES  
DESCRIPTION  
•
•
•
5, 6, 7, 8, 9, or 10 Series-Cell Primary  
Protection  
The bq77PL900 is a five to ten series cell lithium-ion  
battery pack protector. The integrated I2C  
communications interface allows the bq77PL900 also  
to be as an analog front end (AFE) for a Host  
controller. Two LDOs, one 5 V/25 mA and one 3.3  
V/25 mA, are also included and may be used to  
power a host controller or support circuitry.  
PMOS FET Drive for Charge and Discharge  
FETs  
Capable of Operation with 1-mΩ Sense  
Resistor  
•
•
•
•
•
Supply Voltage Range from 7 V to 50 V  
Low Supply Current of 450 µA Typical  
Integrated 5 V 25-mA LDO  
The bq77PL900 integrates a voltage translation  
system to extract battery parameters such as  
individual cell voltages and charge/discharge current.  
Variables such as voltage protection thresholds and  
detection delay times can be programmed by using  
the internal EEPROM.  
Integrated 3.3 V 25-mA LDO  
Stand-Alone Mode  
–
–
–
–
Pack Protection Control and Recovery  
Individual Cell Monitoring  
The bq77PL900 can act as  
a
stand-alone  
Integrated Cell Balancing  
self-contained battery protection system (stand-alone  
mode). It can alternatively be combined with a host  
microcontroller to offer fuel gauge or other battery  
management capabilities to the host system  
(host-control mode).  
Programmable Threshold and Delay Time  
for  
–
–
–
–
Overvoltage  
Undervoltage  
The bq77PL900 provides full safety protection for  
overvoltage, undervoltage, overcurrent in discharge,  
and short circuit in discharge conditions. When the  
EEPROM programmable safety thresholds are  
reached, the bq77PL900 turns off the FET drive  
autonomously. No external components are needed  
to configure the protection features.  
Overcurrent in Discharge  
Short Circuit in Discharge  
–
Fixed Overtemperature Protection  
•
Host Control Mode  
–
–
I2C Interface to Host Controller  
Analog Interface for Host Cell Measurement  
and System Charge/Discharge Current  
The analog front end (AFE) outputs allow a host  
controller to observe individual cell voltages and  
charge/discharge currents. The host controller’s  
analog-to-digital  
bq77PL900 to acquire these values.  
–
–
Host-Controlled Protection Recovery  
Host-Controlled Cell Balancing  
converter  
connects  
to  
the  
Cell balancing can be performed autonomously, or  
the host controller can activate it individually via a cell  
bypass path integrated into the bq77PL900. Internal  
control registers accessible via the I2C interface  
configure this operation. The maximum balancing  
bypass current is set via an external series resistor  
and the internal FET-on resistance (typically 400 Ω).  
Optionally, external bypass cell balance FETs can be  
used for increased current capability.  
APPLICATIONS  
•
•
•
•
•
Cordless Power Tools  
Power Assisted Bicycle/Scooter  
Uninterruptible Power Supply (UPS) Systems  
Medical Equipment  
Portable Test Equipment  
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas  
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
PRODUCTION DATA information is current as of publication date.  
Products conform to specifications per the terms of the Texas  
Instruments standard warranty. Production processing does not  
necessarily include testing of all parameters.  
Copyright © 2008, Texas Instruments Incorporated  
1234567...57

中文翻译

下载PDF

BQ77PL900DL 替代型号

型号 品牌 替代类型 描述 数据表
BQ77PL900DLR TI

类似代替

 Five to Ten Series Cell Lithium-Ion or Lithium-Polymer Battery Protector and Analog Front
BQ77PL900DLG4 TI

类似代替

 Five to Ten Series Cell Lithium-Ion or Lifthium-Polymer Battery Protector and Analog Front
BQ77PL900DLRG4 TI

类似代替

 Five to Ten Series Cell Lithium-Ion or Lifthium-Polymer Battery Protector and Analog Front

与BQ77PL900DL相关器件

型号 品牌 获取价格 描述 数据表
BQ77PL900DLG4 TI

获取价格

 		Five to Ten Series Cell Lithium-Ion or Lifthium-Polymer Battery Protector and Analog Front
BQ77PL900DLR TI

获取价格

 		Five to Ten Series Cell Lithium-Ion or Lithium-Polymer Battery Protector and Analog Front
BQ77PL900DLRG4 TI

获取价格

 		Five to Ten Series Cell Lithium-Ion or Lifthium-Polymer Battery Protector and Analog Front
BQ77PL900_1 TI

获取价格

 		Five to Ten Series Cell Lithium-Ion or Lithium-Polymer Battery Protector and Analog Front
BQ77PL900_2 TI

获取价格

 		Five to Ten Series Cell Lithium-Ion or Lifthium-Polymer Battery Protector and Analog Front
BQ78350-R1A TI

获取价格

 		CEDV 锂离子电池电量监测计和电池管理控制器
BQ78350DBT TI

获取价格

 		最小电池串联数:3;最大电池串联数:15;电池类型:多化学;元器件封装:30-TSSOP;
BQ78350DBT-R1A TI

获取价格

 		CEDV 锂离子电池电量监测计和电池管理控制器 | DBT | 30 | -40 to 8
BQ78350DBTR-R1A TI

获取价格

 		CEDV 锂离子电池电量监测计和电池管理控制器 | DBT | 30 | -40 to 8
BQ78412 TI

获取价格

 		Pb-Acid Battery State-of-Charge Indicator With Run-Time Display

与BQ77PL900DL相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2025 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证