bq24157
www.ti.com
SLUSB80 –SEPTEMBER 2012
Fully Integrated Switch-Mode Charger
With USB Compliance and USB-OTG Support
Check for Samples: bq24157
1
FEATURES
23
•
Power Up System without Battery
•
Synchronous Fixed-Frequency PWM
Controller Operating at 3 MHz With 0% to
•
Charge Faster than Linear Chargers
99.5% Duty Cycle
•
High-Accuracy Voltage and Current Regulation
•
•
Automatic High Impedance Mode for Low
Power Consumption
–
–
–
Input Current Regulation Accuracy: ±5%
(100 mA and 500 mA)
Robust Protection
Charge Voltage Regulation Accuracy:
±0.5% (25°C), ±1% (0°C to 125°C)
–
Reverse Leakage Protection Prevents
Battery Drainage
Charge Current Regulation Accuracy: ±5%
–
–
Thermal Regulation and Protection
Input/Output Overvoltage Protection
•
Input Voltage Based Dynamic Power
Management (VIN DPM)
•
•
•
•
Status Output for Charging and Faults
USB Friendly Boot-Up Sequence
Automatic Charging
•
•
Bad Adaptor Detection and Rejection
Safety Limit Register for Maximum Charge
Voltage and Current Limiting
•
High-Efficiency Mini-USB/AC Battery Charger
for Single-Cell Li-Ion and Li-Polymer Battery
Packs
Boost Mode Operation for USB OTG
–
Input Voltage Range (from Battery): 3.2 V to
4.5 V
•
•
•
•
20-V Absolute Maximum Input Voltage Rating
6.5-V Maximum Operating Input Voltage
Built-In Input Current Sensing and Limiting
•
2.1 mm x 2 mm 20-Pin WCSP Package
APPLICATIONS
•
•
•
Mobile and Smart Phones
MP3 Players
Integrated Power FETs for Up To 1.25-A
Charge Rate
•
Programmable Charge Parameters through
I2C™ Compatible Interface (up to 3.4 Mbps):
Handheld Devices
Figure 1. Typical Application Circuit
–
–
–
–
–
–
Input Current Limit
LO 1.0 mH
RSNS
VBAT
VBUS
VBUS
VIN DPM Threshold
SW
CO1
CIN
CO2
33 mF
U1
bq24157
CBOOT
1 mF
22 mF
Fast-Charge/Termination Current
Charge Regulation Voltage (3.5 V to 4.44 V)
Low Charge Current Mode Enable/Disable
Termination Enable/Disable
33nF
BOOT
PGND
PMID
PACK+
+
4.7 mF
C
IN
2
CCSIN
VAUX
10 kW
0.1 mF
CSIN
10 kW
I
C BUS
10 kW
PACK–
CSOUT
SCL
SCL
SDA
SDA
CCSOUT
0.1 mF
STAT
STAT
VREF
OTG
OTG
CD
CVREF
1 mF
CD
10 kW
10 kW
HOST
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
2
3
NanoFree is a trademark of Texas Instruments.
I2C is a trademark of NXP B.V. Corporation.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2012, Texas Instruments Incorporated