ATS671LSE Specification
Preliminary – Subject to Change
Self Calibrating TPOS Gear Tooth Sensor with
Pin Out Diagram
9Bit Signal Capture
The ATS671LSE true zero speed gear tooth sensors are
optimized Hall IC/magnet configurations packaged in a Single In
Line Package (SIP) that provides a user-friendly solution for digital
gear tooth sensing applications. The SIP module consists of an
over-molded package, which holds together a samarium cobalt
magnet, a pole piece and a true zero-speed Hall IC that has been
optimized to the magnetic circuit. This package can be easily
assembled and used in conjunction with gears of various shapes
and sizes.
The sensor incorporates a single element Hall IC that switches
in response to the magnetic signal created by a ferrous target. The
IC contains a sophisticated digital circuit designed to eliminate the
detrimental effects of magnet and system offsets. Signal processing
is used to provide zero speed performance independent of air gap
and also to dynamically adapt device performance to the typical
operating conditions found in automotive applications (reduced
vibration sensitivity). High-resolution (9-bit) peak detecting DACs
are used to set the adaptive switching thresholds of the device.
Hysteresis in the thresholds reduces the negative effects of any
anomalies in the magnetic signal (such as magnetic overshoot)
associated with the targets used in many automotive applications.
The ATS671LSE also includes a low bandwidth filter that increases
the noise immunity and the signal to noise ratio of the sensor.
These features result in potential improvements in both the timing
accuracy and the jitter performance of the device.
Pin 1: VCC
Pin 2: VOUT
Pin 3: Test Pin (Tie to GND)
Pin 4: Gnd
The ATS671LSE-LT sensor system is optimized for cam
applications and is available with or without the TPOS function
ABSOLUTE MAXIMUM RATINGS
Supply Voltage,
FEATURES
VCC . . . . . . . . . . . . . . . . . . . . . . . . . . 26.5 V
Reverse Supply Voltage,
VR . . . . . . . . . . . . . . . . . . . . . . . . . . . . –18 V
Reverse Output Voltage,
VORout . . . . . . . . . . . . . . . . . . . . . . . . . -0.5 V
Continuous Output Current,
IOUT . . . . . . . . . . . . . . . . . . . . . . . . . . 20 mA
Storage Temperature,
TS . . . . . . . . . . . . . . . . . . . . . . . . . . . 170° C
Package Power Rating,
sTight timing accuracy over temperature
sTrue zero speed operation
sTrue power on state
sAir gap independent switch points
sHigh vibration immunity
sLarge operating air gaps
sOperation down to 3.3V
sDigital output representing target profile
sSingle chip solution for high reliability
sSmall mechanical size
sOptimized Hall IC magnetic system
sAGC and reference adjust circuit
sUnder-voltage lockout
J
JA .SB. . . . . . . . . . . . . . . . . . . ~150° C/W
Maximum Junction Temperature,
TJmax . . . . . . . . . . . . . . . . . . . . . . . . . 170° C
Maximum Junction Temperature – 100 Hours,
TJmax . . . . . . . . . . . . . . . . . . . . . . . . . 180° C