ATH06T033 Series —3.3-V Input
6-A, 3.3-V Input Non-Isolated
Wide-Output Adjust Power Module
REVISION 00 (01DEC2003)
Features
• Up to 6-A Output Current
• 3.3-V Input Voltage
• Wide-Output Voltage Adjust
(0.8 V to 2.5 V)
• Auto-Track™ Sequencing
• Output Over-Current Protection
(Non-Latching, Auto-Reset)
• IPC Lead Free 2
• Efficiencies up to 94 %
• 103 W/in³ Power Density
• On/Off Inhibit
• Pre-Bias Startup
• Under-Voltage Lockout
• Operating Temp: –40 to +85 °C
• Safety Agency Approvals (Pending)
UL 1950, CSA 22.2 950, &
EN60950
• Point-of-Load Alliance (POLA)
Compatible
NOMINAL SIZE =
0.87 in x 0.5 in
(22,1 mm x 12,57 mm)
Description
Pin Configuration
The ATH06T033 series is one of the
smallest non-isolated power modules that
features Auto-Track™. Auto-Track™
simplifies supply voltage sequencing in
power systems by enabling modules to track
each other, or any other external voltage,
duringpower up and power down.
single resistor.
Pin Function
1
2
3
4
5
6
GND
Track
Vin
Inhibit *
Vo Adjust
Vout
Other operating features include an
on/off inhibit, output voltage adjust (trim),
and output over-current protection. For
high efficiency these parts employ a
synchronous rectifier output stage, but a
pre-bias hold-off capability ensures that
the output will not sink current during
startup.
Target applications include telecom,
industrial, and general purpose circuits,
including low-power dual-voltage systems
that use a DSP, microprocessor, ASIC, or
FPGA.
*
Denotes negative logic:
Although small in size (0.87 in × 0.5 in),
these modules are rated for up to 6 A of
output current, and are an ideal choice in
applications where space, performance,
and a power-up sequencing capability are
important attributes.
The product provides high-performance
step-down conversion from a 3.3-V input
bus voltage. The output voltage of the
ATH06T033 can be set to any voltage
over the range, 0.8 V to 2.5 V, using a
Open
= Normal operation
Ground = Function active
Package options include both through-
hole and surface mount configurations.
Standard Application
R
= Required to set the output voltage to a value
higher than 0.8 V. (See spec. table for values)
set
C
= Required 100 µF
in
1
Co = Optional 100 µF capacitor
Co2 = Optional 10 µF ceramic capacitor for reduced
output ripple.
Track
VIN
VOUT
1
2
3
4
6
5
PTH03050W
ATH06T033-9S
(Top View)
Co1
100 µF
Electrolytic
(Optional)
Co2
10 µF
Ceramic
(Optional)
CIN
100 µF
(Required)
RSET
1 %, 0.1 W
(Required)
Inhibit
GND
GND
North America (USA): 1-888-41-ASTEC
Europe (UK): 44(1384)842-211
Asia (HK): 852-2437-9662