5秒后页面跳转
AT29LV020-10JU PDF预览

AT29LV020-10JU

更新时间: 2024-09-20 06:38:19
品牌 Logo 应用领域
爱特美尔 - ATMEL /
页数 文件大小 规格书
16页 388K
描述
2-megabit (256K x 8) 3-volt Only Flash Memory

AT29LV020-10JU 数据手册

 浏览型号AT29LV020-10JU的Datasheet PDF文件第2页浏览型号AT29LV020-10JU的Datasheet PDF文件第3页浏览型号AT29LV020-10JU的Datasheet PDF文件第4页浏览型号AT29LV020-10JU的Datasheet PDF文件第5页浏览型号AT29LV020-10JU的Datasheet PDF文件第6页浏览型号AT29LV020-10JU的Datasheet PDF文件第7页 
Features  
Single Voltage, Range 3V to 3.6V Supply  
3-volt Only Read and Write Operation  
Software Protected Programming  
Fast Read Access Time – 100 ns  
Low Power Dissipation  
– 15 mA Active Current  
– 50 µA CMOS Standby Current  
Sector Program Operation  
2-megabit  
(256K x 8)  
3-volt Only  
Flash Memory  
– Single Cycle Reprogram (Erase and Program)  
– 1024 Sectors (256 Bytes/Sector)  
– Internal Address and Data Latches for 256 Bytes  
Two 8K Bytes Boot Blocks with Lockout  
Fast Sector Program Cycle Time – 20 ms  
Internal Program Control and Timer  
DATA Polling for End of Program Detection  
Typical Endurance > 10,000 Cycles  
CMOS and TTL Compatible Inputs and Outputs  
Green (Pb/Halide-free) Packaging Option  
AT29LV020  
1. Description  
The AT29LV020 is a 3-volt-only in-system Flash programmable and erasable read  
only memory (PEROM). Its 2 megabits of memory is organized as 262,144 bytes by  
8 bits. Manufactured with Atmel’s advanced nonvolatile CMOS technology, the device  
offers access times to 100 ns with power dissipation of just 54 mW over the industrial  
temperature range. When the device is deselected, the CMOS standby current is less  
than 50 µA. The device endurance is such that any sector can typically be written to in  
excess of 10,000 times.  
To allow for simple in-system reprogrammability, the AT29LV020 does not require  
high input voltages for programming. Five-volt-only commands determine the opera-  
tion of the device. Reading data out of the device is similar to reading from an  
EPROM. Reprogramming the AT29LV020 is performed on a sector basis; 256 bytes  
of data are loaded into the device and then simultaneously programmed.  
During a reprogram cycle, the address locations and 256 bytes of data are captured at  
microprocessor speed and internally latched, freeing the address and data bus for  
other operations. Following the initiation of a program cycle, the device will automati-  
cally erase the sector and then program the latched data using an internal control  
timer. The end of a program cycle can be detected by DATA polling of I/O7. Once the  
end of a program cycle has been detected, a new access for a read or program can  
begin.  
0565E–FLASH–9/08  

AT29LV020-10JU 替代型号

型号 品牌 替代类型 描述 数据表
AT29LV020-10JI ATMEL

类似代替

Flash, 256KX8, 100ns, PQCC32, PLASTIC, MS-016AE, LCC-32

与AT29LV020-10JU相关器件

型号 品牌 获取价格 描述 数据表
AT29LV020-10TI ATMEL

获取价格

Flash, 256KX8, 100ns, PDSO32, 8 X 20 MM, PLASTIC, MO-142BD, TSOP1-32
AT29LV020-10TU ATMEL

获取价格

2-megabit (256K x 8) 3-volt Only Flash Memory
AT29LV020-12JC ATMEL

获取价格

Flash, 256KX8, 120ns, PQCC32, PLASTIC, MS-016AE, LCC-32
AT29LV020-12JI ATMEL

获取价格

Flash, 256KX8, 120ns, PQCC32, PLASTIC, MS-016AE, LCC-32
AT29LV020-12JU ATMEL

获取价格

Flash, 256KX8, 120ns, PQCC32, PLASTIC, MS-016AE, LCC-32
AT29LV020-12TU ATMEL

获取价格

Flash, 256KX8, 120ns, PDSO32, 8 X 20 MM, PLASTIC, MO-142BD, TSOP1-32
AT29LV020-20 ATMEL

获取价格

2 Megabit 256K x 8 3-volt Only CMOS Flash Memory
AT29LV020-20DC ETC

获取价格

x8 Flash EEPROM
AT29LV020-20DI ETC

获取价格

x8 Flash EEPROM
AT29LV020-20JC ATMEL

获取价格

2 Megabit 256K x 8 3-volt Only CMOS Flash Memory