Features
• Serial Peripheral Interface (SPI) Compatible
• Supports SPI Modes 0 (0,0) and 3 (1,1)
– Data Sheet Describes Mode 0 Operation
• Medium-voltage and Standard-voltage Operation
– 5.0 (VCC = 4.5V to 5.5V)
– 2.7 (VCC = 2.7V to 5.5V)
• 5.0 MHz Clock Rate (5V)
• 32-byte Page Mode
• Block Write Protection
– Protect 1/4, 1/2, or Entire Array
• Write Protect (WP) Pin and Write Disable Instructions for both Hardware and Software
Data Protection
• Self-timed Write Cycle (2 ms [5V] typical)
• High Reliability
SPI Serial
Automotive
EEPROMs
– Endurance: One Million Write Cycles
– Data Retention: 100 Years
8K (1024 x 8)
16K (2048 x 8)
32K (4096 x 8)
64K (8192 x 8)
• 8-lead PDIP and 8-lead JEDEC SOIC Packages
Description
The AT25080A/160A/320A/640A provides 8192/16384/32768/65536 bits of serial
electrically-erasable programmable read-only memory (EEPROM) organized as
1024/2048/4096/8192 words of 8 bits each. The device is optimized for use in many
automotive applications where low-power and low-voltage operation are essential.
The AT25080A/160A/320A/640A is available in space saving 8-lead PDIP and 8-lead
JEDEC SOIC packages.
AT25080A
AT25160A
AT25320A
AT25640A
The AT25080A/160A/320A/640A is enabled through the Chip Select pin (CS) and
accessed via a three-wire interface consisting of Serial Data Input (SI), Serial Data
Output (SO), and Serial Clock (SCK). All programming cycles are completely self-
timed, and no separate erase cycle is required before write.
Block write protection is enabled by programming the status register with one of four
blocks of write protection. Separate program enable and program disable instructions
are provided for additional data protection. Hardware data protection is provided via
the WP pin to protect against inadvertent write attempts to the status register. The
HOLD pin may be used to suspend any serial communication without resetting the
serial sequence.
8-lead PDIP
Table 1. Pin Configuration
Pin Name
CS
Function
CS
SO
1
8
7
6
5
VCC
HOLD
SCK
SI
Chip Select
2
3
4
SCK
SI
Serial Data Clock
Serial Data Input
Serial Data Output
Ground
WP
GND
SO
GND
VCC
WP
8-lead SOIC
Power Supply
Write Protect
Suspends Serial Input
No Connect
CS
SO
1
8
7
6
5
VCC
HOLD
SCK
SI
2
3
4
HOLD
NC
WP
GND
DC
Don’t Connect
3401D–SEEPR–1/05
1