AN44
A high power LED driver for low voltage halogen replacement
Introduction
LED lighting is becoming more popular as a replacement technology for Halogen low voltage
lighting, primarily because of the low efficiency, reliability and lifetime issues associated with
Halogen bulbs.
Discussed below is a novel approach for driving high power LED's as a replacement for low
voltage halogen lighting systems.
A typical schematic diagram is shown in Figure 1.
Figure 1 Schematic diagram
Operation
Please refer to the typical schematic diagram in Figure 1.
On period, T
ON
The ZXSC300 turns on Q1 until it senses 19mV (nominal) on the I
pin.
SENSE
The current in Q1 to reach this threshold is therefore 19mV/R1, called I
.
PEAK
With Q1 on, the current is drawn from the battery and passes through C1 and LED in parallel.
Assume the LED drops a forward voltage V . The rest of the battery voltage will be dropped across
F
L1 and this voltage, called V(L1) will ramp up the current in L1 at a rate di/dt = V(L1)/L1, di/dt in
Amps/sec, V(L1) in volts and L1 in Henries.
The voltage drop in Q1 and R1 should be negligible, since Q1 should have a low R
always drops less than 19mV, as this is the turn-off threshold for Q1.
and R1
DS(on)
V
= V + V(L1)
F
IN
T
= I
x L1/ V(L1)
ON
PEAK
Issue 2 - July 2006
© Zetex Semiconductors plc 2006
1
www.zetex.com