Application Note
AN3008
Using the DR65-0109 to Drive SPDT PIN Switches
Rev. V2
Introduction
Pin Assignments
For use as a replacement part to the DR65-0003
PIN Driver.
Pin#
Function
Pin #
Function
1
Vcc
5
Ground
This Application Note describes how to use the
M/A-COM DR65-0109 Single Channel Driver for
FET Switches as a SP2T PIN Diode Driver. When
configured per the directions herein, the DR65-0109
will provide the same functionality as the DR65-0003
in the same package style, HOWEVER THE
PINOUT IS DIFFERENT. USING THE DR65-0109
Non-Inverting
Output
2
Logic Input
6
3
4
Vdd
7
8
Inverting Output
Vee
Ground
AS
A
DIRECT DROP-IN REPLACEMENT
WITHOUT DOING A PCB CHANGE WILL NOT
Electrical Specifications: TA = +25°C, +Vcc = + Vdd = + 5.0V ± 5%, -Vee = - 5.0V ± 5%
Parameter
Test Conditions
Units
Min
Typical
Max
Spike current into 10 ohm load
50 % TTL to 90%
Switching Speed1 Delay
Rt/Ft
nS
nS
—
—
25
2
35
5
10%-90%; 90%-10%
PRF
50% duty cycle
MHz
V
DC
—
—
—
5
Output Voltage Drop, No Load
With reference to supply voltage
.25
DC Output Current
Peak Spike Output Current
Load Dependent
Spiking Capacitor in Circuit
mA
mA
—
—
±30
±150
±50
±200
Positive Output FET, Qp
Negative Output FET, Qn
W
W
—
—
15
25
—
—
Output Stage on Resistance
Quiescent Supply Currents
TTL Levels
+5V
-5V
mA
mA
—
—
—
—
1.0
.2
Logic “0” @ 20 µA sink current
Logic “1” @ 20 µA source current
V
V
0
2.0
—
—
.8
5.0
Package Dissipation
—
mW
—
—
200
1. Decoupling capacitors (.01 µF) are required on power supply lines.
Equivalent Output Circuit for Pins 6 & 7
.1V
15 ohms
Vdd
Pin 6 &
Pin 7
Vee
.1V
25 ohms
1
• North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400
• India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588
Visit www.macomtech.com for additional data sheets and product information.
M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
changes to the product(s) or information contained herein without notice.