Data Sheet
AS1301
5V/50mA Low Noise Inductorless Boost Converter
1 General Description
2 Key Features
ꢀ Up to 92% Efficiency
The AS1301 is a 50mA inductorless boost converter
using a double H-bridge charge-pump topology with two
external flying capacitors.
ꢀ 2.7 to 5.25V Input Voltage
ꢀ Regulated 5V Output
The AS1301 runs on a 1MHz fixed frequency and is
utilized with a low noise regulation scheme to allow
usage together with sensitive RF circuitry from the same
battery supply.
ꢀ Automatic Mode Up-Switching
ꢀ <5µA Shutdown Current
ꢀ 5V Tolerant Enable Signal
ꢀ Up to 50mA Load Current
ꢀ Overload Protection
Designed to reside in portable and space limited
equipment the 1MHz charge pump converts a 2.7 to
5.25V input to regulated 5V output with 5% accuracy.
ꢀ Output Disconnected During Shutdown
ꢀ Soft-Start
The shutdown function reduces the supply current to
<5µA and disconnects the load from the output. The
integrated soft-start circuitry prevents current spikes
being drawn from the battery during start-up.
ꢀ No Inductor Required
ꢀ Small External Components Required
(COUT ≤2.2µF, CFLY ≤220nF)
The AS1301 is available in TDFN (3x3x0.8mm) 10-pin
and WL-CSP 8-bumps packages.
ꢀ Low Noise Fixed Frequency 1MHz Charge Pump:
- 1:1 Battery Feed Through Mode
- 2:3 Single Phase Mode
- 1:2 Dual Phase Mode
ꢀ Package Options:
- TDFN (3x3x0.8mm) 10-pin
- WL-CSP 8-bumps with 0.5mm pitch
3 Applications
The device is ideal for two or three AA cells or a single
Li-Ion battery cell to 5V conversion, mobile phones,
portable instruments, microprocessor based systems
and remote data-acquisition systems.
Figure 1. Typical Application Diagram
CFLY1
C1+
CFLY2
C2+
C2-
C1-
VOUT = 5V
VBATT
VBATT
VOUT
GND
+
CBAT
COUT
2.2µF
2.2µF
AS1301
On
Off
EN
www.austriamicrosystems.com
Revision 1.03
1 - 16