5秒后页面跳转
AMIS-52100 PDF预览

AMIS-52100

更新时间: 2024-01-18 12:18:21
品牌 Logo 应用领域
AMI 电信集成电路电信电路光电二极管时钟
页数 文件大小 规格书
26页 1576K
描述
Transceiver with Clock and Data Recovery

AMIS-52100 技术参数

生命周期:ActiveReach Compliance Code:compliant
风险等级:5.7Is Samacsys:N
JESD-30 代码:R-PDSO-G20端子数量:20
最高工作温度:50 °C最低工作温度:
封装主体材料:PLASTIC/EPOXY封装代码:SSOP
封装等效代码:SSOP20,.3封装形状:RECTANGULAR
封装形式:SMALL OUTLINE, SHRINK PITCH电源:3 V
认证状态:Not Qualified子类别:Other Telecom ICs
最大压摆率:25 mA标称供电电压:3 V
表面贴装:YES温度等级:COMMERCIAL
端子形式:GULL WING端子节距:0.635 mm
端子位置:DUALBase Number Matches:1

AMIS-52100 数据手册

 浏览型号AMIS-52100的Datasheet PDF文件第2页浏览型号AMIS-52100的Datasheet PDF文件第3页浏览型号AMIS-52100的Datasheet PDF文件第4页浏览型号AMIS-52100的Datasheet PDF文件第5页浏览型号AMIS-52100的Datasheet PDF文件第6页浏览型号AMIS-52100的Datasheet PDF文件第7页 
AMIS-52100 Low-Power Transceiver with Clock and Data Recovery  
Data Sheet  
1.0 Introduction  
The AMIS-52100 is a low-cost, ultra-low power single chip transceiver. It combines the proven amplitude shift key/on-off key  
(ASK/OOK) modulation technology of the AMIS-52000 with data clock recovery. The AMIS-52100 is targeted at narrow band  
applications in the 402 to 405MHz range.  
Features such as dual independent receive channels, quick start crystal oscillator start up, Sniff Mode™ signal acquisition, and data  
clock recovery make the AMIS-52100 ideally suited for a wide range of customer applications. Applications that the AMIS-52100 can be  
used for are point-to-point wireless data links, low cost wireless monitors, very low power remote wireless sensors, and many other  
uses.  
2.0 Key Features  
Data clock recovery  
Auto slicing of data  
Very low-power single-chip transceiver  
Minimal external components  
Low-power RC oscillator  
Quick Start for the crystal oscillator  
Extreme low-power RF Sniff Mode™, wakes on RSSI  
Internal trim functions reduce external component requirements  
I2C control interface  
Serial TX/RX data port  
Clock generation for an external microprocessor  
Wake up on RSSI  
Antenna diversity dual receiver  
Internal VCO/PLL tuning varactor  
Application wakeup interrupt to external controller  
3.0 Technical Features  
Operating Frequency:  
o
o
o
Quick Start range 350 to 448MHz  
Non-Quick Start range 300 to 768MHz  
Targeted range 402 to 405MHz  
TX Output Power: +12dBm  
RX Sensitivity:  
o
o
Sniff Mode: -93dBm minimum  
Receive: -117dBm minimum @ 1Kbps with CDR  
Data Rate:  
o
o
1 to 8Kbps with Manchester Coding  
1 to 16Kbps with NRZ data  
Power Requirements:  
o
o
o
o
Receive: 7.5mA (continuous)  
Transmit: 25mA full power; 50 percent duty cycle  
Sniff Mode: 75uA (one percent duty cycle)  
Standby: 500nA (RC oscillator running)  
Operating Voltage: 2.3 to 3.6V  
Modulation: ASK/OOK  
Xtal Start Time: 15us (Quick Start)  
Sniff Mode Polling: 0.5ms to 16s (0.5ms or 64ms steps)  
AMI Semiconductor – Rev 4.0, Mar. 06 – M-20535-004  
1
www.amis.com  

与AMIS-52100相关器件

型号 品牌 描述 获取价格 数据表
AMIS-52100-A AMI Transceiver with Clock and Data Recovery

获取价格

AMIS-52100-A ONSEMI IC,RF MODULATOR/DEMODULATOR,SSOP,20PIN,PLASTIC

获取价格

AMIS-52100-I AMI Transceiver with Clock and Data Recovery

获取价格

AMIS-52100-I ONSEMI IC,RF MODULATOR/DEMODULATOR,SSOP,20PIN,PLASTIC

获取价格

AMIS-52100-M AMI Transceiver with Clock and Data Recovery

获取价格

AMIS-52100-M ONSEMI IC,RF MODULATOR/DEMODULATOR,SSOP,20PIN,PLASTIC

获取价格