AH374
SINGLE PHASE HALL EFFECT LATCH
Description
Pin Assignments
The AH374 is an integrated Hall-Effect latched sensor designed for
electronic commutation of brush-less DC motor applications. The
device includes an on-chip Hall voltage generator for magnetic
sensing, a comparator that amplifies the Hall voltage, and a Schmitt
trigger to provide switching hysteresis for noise rejection, and open
drain output. An internal band-gap regulator provides a temperature
compensated supply voltage for internal circuits and allows a wide
operating supply range.
(Top View)
3. OUT
1. VDD
GND 2.
SC59 and SOT23
(Top View)
3. OUT
2. GND
When the magnetic flux density (B) is larger than operate point (BOP),
output is switched on (OUT pin is pulled low). The output state is held
on until a magnetic flux density reversal falls below BRP. When B is
less than BRP, the output is switched off.
VDD
1.
SIP-3 (Bulk Pack)
The AH374 is available in SIP-3 (Ammo Pack), SIP-3 (Bulk Pack),
SC59 and SOT23 packages.
Applications
Features
•
•
•
•
Brush-Less DC Motor
Brush-Less DC Fan
Revolution Counting
Speed Measurement
Bipolar Hall Effect Latch Operation
2.2V to 20V Operating Range
Open Drain Pre-Driver
25mA Output Sink Capability
-40C to +125°C Operating Temperature
Industry Standard SIP-3 (Ammo Pack), SIP-3 (Bulk Pack), SC59
and SOT23 Packages
Totally Lead-Free & Fully RoHS Compliant (Notes 1 & 2)
Halogen and Antimony Free. “Green” Device (Note 3)
Notes:
1. No purposely added lead. Fully EU Directive 2002/95/EC (RoHS) & 2011/65/EU (RoHS 2) compliant.
2. See http://www.diodes.com/quality/lead_free.html for more information about Diodes Incorporated’s definitions of Halogen- and Antimony-free, "Green"
and Lead-free.
3. Halogen- and Antimony-free "Green” products are defined as those which contain <900ppm bromine, <900ppm chlorine (<1500ppm total Br + Cl) and
<1000ppm antimony compounds.
Typical Application Circuits
VDD
RL
OUTPUT
AH374
CIN
GND
Typical AH374 Circuit
Note:
4. CIN is for power stabilization and to strengthen the noise immunity, the recommended capacitance is 10nF ~ 100nF.
is the pull-up resistor, the recommended resistance is 10k ~ 100k.
R
L
1 of 12
www.diodes.com
December 2016
© Diodes Incorporated
AH374
Document number: DS39163 Rev. 1 - 2