3 V LVDS Quad CMOS
Differential Line Driver
Data Sheet
ADN4667
FEATURES
FUNCTIONAL BLOCK DIAGRAM
V
CC
15 kV ESD protection on output pins
400 Mbps (200 MHz) switching rates
Flow through pinout simplifies PCB layout
300 ps typical differential skew
400 ps maximum differential skew
1.7 ns maximum propagation delay
3.3 V power supply
ADN4667
D
D
OUT1+
D1
D2
D3
D4
D
D
D
D
IN1
IN2
IN3
IN4
OUT1–
D
D
OUT2+
OUT2–
D
D
OUT3+
310 mV differential signaling
OUT3–
Low power dissipation (10 mW typical)
Interoperable with existing 5 V LVDS receivers
High impedance on LVDS outputs on power-down
Conforms to TIA/EIA-644 LVDS standards
Industrial operating temperature range: −40°C to +85°C
Available in surface-mount (SOIC) and low profile
TSSOP package
D
D
OUT4+
OUT4–
EN
EN
GND
Figure 1.
Qualified for automotive applications
APPLICATIONS
Backplane data transmission
Cable data transmission
Clock distribution
GENERAL DESCRIPTION
The ADN4667 is a quad, CMOS, low voltage differential signaling
(LVDS) line driver offering data rates of over 400 Mbps (200 MHz)
and ultralow power consumption. It features a flow through
pinout for easy PCB layout and separation of input and output
signals.
The ADN4667 also offers active high and active low enable/
EN
disable inputs (EN and ). These inputs control all four drivers
and turn off the current outputs in the disabled state to reduce
the quiescent power consumption to typically 10 mW.
The ADN4667 and its companion LVDS receiver, the ADN4668,
offer a new solution to high speed, point-to-point data trans-
mission, and a low power alternative to emitter-coupled logic
(ECL) or positive emitter-coupled logic (PECL).
The device accepts low voltage TTL/CMOS logic signals and
converts them to a differential current output of typically 3.1 mA
for driving a transmission medium such as a twisted pair cable.
The transmitted signal develops a differential voltage of typi-
cally 310 mV across a termination resistor at the receiving end.
This is converted back to a TTL/CMOS logic level by an LVDS
receiver, such as the ADN4668.
Rev. B
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rightsof third parties that may result fromits use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks andregisteredtrademarks are the property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
www.analog.com
Fax: 781.461.3113 ©2008–2012 Analog Devices, Inc. All rights reserved.