5秒后页面跳转
捷配首页

Datasheet > 传感器/换能器 > 温度传感器> ADM1030ARQ-REEL
ADM1030ARQ-REEL PDF预览

ADM1030ARQ-REEL

更新时间： 2024-11-21 06:36:19
品牌 Logo 应用领域
安森美 - ONSEMI 风扇传感器换能器温度传感器输出元件监控控制器
页数 文件大小 规格书
29页 558K
描述
Intelligent Temperature Monitor and PWM Fan Controller

阅读下载

中文翻译

获取价格

ADM1030ARQ-REEL 技术参数

是否Rohs认证：不符合生命周期：Obsolete
Reach Compliance Code：not_compliant风险等级：5.17
Is Samacsys：N最大精度（摄氏度）：1 Cel
主体宽度：3.91 mm主体高度：1.44 mm
主体长度或直径：4.9 mmJESD-609代码：e0
安装特点：SURFACE MOUNT位数：8
最大工作电流：3 mA最高工作温度：100 °C
最低工作温度：输出接口类型：2-WIRE INTERFACE
封装形状/形式：RECTANGULAR传感器/换能器类型：TEMPERATURE SENSOR,SWITCH/DIGITAL OUTPUT,SERIAL
最大供电电压：5.5 V最小供电电压：3 V
表面贴装：YES端子面层：Tin/Lead (Sn/Pb)
端接类型：SOLDERBase Number Matches：1

ADM1030ARQ-REEL 数据手册

 浏览型号ADM1030ARQ-REEL的Datasheet PDF文件第2页浏览型号ADM1030ARQ-REEL的Datasheet PDF文件第3页浏览型号ADM1030ARQ-REEL的Datasheet PDF文件第4页浏览型号ADM1030ARQ-REEL的Datasheet PDF文件第5页浏览型号ADM1030ARQ-REEL的Datasheet PDF文件第6页浏览型号ADM1030ARQ-REEL的Datasheet PDF文件第7页 
Intelligent Temperature  
Monitor and PWM Fan Controller  
ADM1030*  
FEATURES  
PRODUCT DESCRIPTION  
Optimized for Pentium® III: Allows Reduced Guardbanding  
Software and Automatic Fan Speed Control  
Automatic Fan Speed Control Allows Control Independent  
of CPU Intervention after Initial Setup  
Control Loop Minimizes Acoustic Noise and Battery  
Consumption  
Remote Temperature Measurement Accurate to 1�C  
Using Remote Diode  
0.125�C Resolution on Remote Temperature Channel  
Local Temperature Sensor with 0.25�C Resolution  
Pulsewidth Modulation Fan Control (PWM)  
Programmable PWM Frequency  
Programmable PWM Duty Cycle  
Tach Fan Speed Measurement  
Analog Input To Measure Fan Speed of 2-Wire Fans  
(Using Sense Resistor)  
2-Wire System Management Bus (SMBus) with ARA  
Support  
The ADM1030 is an ACPI-compliant two-channel digital ther-  
mometer and under/over temperature alarm, for use in computers  
and thermal management systems. Optimized for the Pentium  
III, the higher 1rC accuracy offered allows systems designers to  
safely reduce temperature guardbanding and increase system  
performance. A Pulsewidth Modulated (PWM) Fan Control out-  
put controls the speed of a cooling fan by varying output duty  
cycle. Duty cycle values between 33%–100% allow smooth  
control of the fan. The speed of the fan can be monitored via a  
TACH input for a fan with a tach output. The TACH input can  
be programmed as an analog input, allowing the speed of a 2-wire  
fan to be determined via a sense resistor. The device will also  
detect a stalled fan. A dedicated Fan Speed Control Loop pro-  
vides control even without the intervention of CPU software. It  
also ensures that if the CPU or system locks up, the fan can still  
be controlled based on temperature measurements, and the fan  
speed adjusted to correct any changes in system temperature.  
Fan Speed may also be controlled using existing ACPI software.  
One input (two pins) is dedicated to a remote temperature-  
sensing diode with an accuracy of ±1rC, and a local temperature  
sensor allows ambient temperature to be monitored. The device  
has a programmable INT output to indicate error conditions.  
There is a dedicated FAN_FAULT output to signal fan failure.  
The THERM pin is a fail-safe output for over-temperature  
conditions that can be used to throttle a CPU clock.  
Overtemperature THERM Output Pin  
Programmable INT Output Pin  
Configurable Offset for All Temperature Channels  
3 V to 5.5 V Supply Range  
Shutdown Mode to Minimize Power Consumption  
APPLICATIONS  
Notebook PCs, Network Servers and Personal Computers  
Telecommunications Equipment  
FUNCTIONAL BLOCK DIAGRAM  
V
CC  
ADD  
SDA  
SCL  
SERIAL BUS  
INTERFACE  
SLAVE  
ADM1030  
ADDRESS  
NC  
REGISTER  
ADDRESS  
POINTER  
REGISTER  
FAN  
NC  
NC  
CHARACTERISTICS  
REGISTER  
INT  
FAN SPEED  
PWM  
INTERRUPT  
STATUS  
REGISTER  
THERM  
CONFIG  
PWM_OUT  
CONTROLLER  
REGISTER  
FAN_FAULT  
T
/T  
MIN RANGE  
LIMIT  
COMPARATOR  
REGISTER  
FAN  
TACH SIGNAL  
CONDITIONING  
TACH/AIN  
SPEED  
VALUE AND LIMIT  
REGISTERS  
COUNTER  
D+  
D–  
NC  
OFFSET  
REGISTERS  
ANALOG  
MULTIPLEXER  
ADC  
BANDGAP  
TEMPERATURE  
SENSOR  
CONFIGURATION  
REGISTER  
2.5V  
BANDGAP  
REFERENCE  
*Patents pending.  
NC = NO CONNECT  
GND  
E
.
©2008 SCILLC. All rights reserved.  
February 2008 - Rev. 2  
Publication Order Number:  
ADM1030/D  
1234567...29

中文翻译

下载PDF

ADM1030ARQ-REEL 替代型号

型号 品牌 替代类型 描述 数据表
ADM1030ARQ ONSEMI

完全替代

 Intelligent Temperature Monitor and PWM Fan Controller
ADM1030ARQZ-RL7 ONSEMI

完全替代

 Intelligent Temperature Monitor and PWM Fan Controller

与ADM1030ARQ-REEL相关器件

型号 品牌 获取价格 描述 数据表
ADM1030ARQ-REEL7 ONSEMI

获取价格

 		Intelligent Temperature Monitor and PWM Fan Controller
ADM1030ARQ-REEL7 ROCHESTER

获取价格

 		DIGITAL TEMP SENSOR-SERIAL, 8BIT(s), 1Cel, RECTANGULAR, SURFACE MOUNT, MO-137AB, QSOP-16
ADM1030ARQZ ONSEMI

获取价格

 		Intelligent Temperature Monitor and PWM Fan Controller
ADM1030ARQZ ROCHESTER

获取价格

 		DIGITAL TEMP SENSOR-SERIAL, 8BIT(s), 1Cel, RECTANGULAR, SURFACE MOUNT, MO-137AB, QSOP-16
ADM1030ARQZ-REEL ONSEMI

获取价格

 		Intelligent Temperature Monitor and PWM Fan Controller
ADM1030ARQZ-RL7 ONSEMI

获取价格

 		Intelligent Temperature Monitor and PWM Fan Controller
ADM1031 ONSEMI

获取价格

 		Intelligent Temperature Monitor and Dual PWM Fan Controller
ADM1031 ADI

获取价格

 		Intelligent Temperature Monitor and Dual PWM Fan Controller
ADM1031ARQ ADI

获取价格

 		Intelligent Temperature Monitor and Dual PWM Fan Controller
ADM1031ARQ-REEL ONSEMI

获取价格

 		Switch/Digital Output Temperature Sensor, DIGITAL TEMP SENSOR-SERIAL, 11BIT(s), 3Cel, RECT

与ADM1030ARQ-REEL相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证