April 2002
ADC10D020
Dual 10-Bit, 20 MSPS, 150 mW A/D Converter
General Description
Features
n Internal sample-and-hold
n Internal reference capability
n Dual gain settings
n Offset correction
The ADC10D020 is a dual low power, high performance
CMOS analog-to-digital converter that digitizes signals to 10
bits resolution at sampling rates up to 30 MSPS while con-
suming a typical 150 mW from a single 3.0V supply. No
missing codes is guaranteed over the full operating tempera-
ture range. The unique two stage architecture achieves 9.5
Effective Bits over the entire Nyquist band at 20 MHz sample
rate. An output formatting choice of straight binary or 2’s
complement coding and a choice of two gain settings eases
the interface to many systems. Also allowing great flexibility
n Selectable straight binary or 2’s complement output
n Multiplexed or parallel output bus
n Single +2.7V to 3.6V operation
n Power down and standby modes
of use is a selectable 10-bit multiplexed or 20-bit parallel Key Specifications
output mode. An offset correction feature minimizes the off-
n Resolution
10 Bits
20 MSPS
set error.
n Conversion Rate
To ease interfacing to most low voltage systems, the digital
output power pins of the ADC10D020 can be tied to a
separate supply voltage of 1.5V to 3.6V, making the outputs
n ENOB
n DNL
9.5 Bits (typ)
0.35 LSB (typ)
2.5 Clock Cycles
2.5 Clock Cycles
3 Clock Cycles
90 dB
n Conversion Latency Parallel Outputs
compatible with other low voltage systems. When not con-
— Multiplexed Outputs, I Data Bus
verting, power consumption can be reduced by pulling the
— Multiplexed Outputs, Q Data Bus
PD (Power Down) pin high, placing the converter into a low
n PSRR
power state where it typically consumes less than 1 mW and
n Power Consumption—Normal Operation 150 mW (typ)
— Power Down Mode
— Fast Recovery Standby Mode
from which recovery is less than 1 ms. Bringing the STBY
(Standby) pin high places the converter into a standby mode
where power consumption is about 27 mW and from which
recovery is 800 ns.
<
1 mW (typ)
27 mW (typ)
Applications
n Digital Video
n CCD Imaging
The ADC10D020’s speed, resolution and single supply op-
eration makes it well suited for a variety of applications,
including high speed portable applications.
Operating over the industrial (−40˚ ≤ TA ≤ +85˚C) tempera-
ture range, the ADC10D020 is available in a 48-pin TQFP. An
evaluation board is available to ease the design effort.
n Portable Instrumentation
n Communications
n Medical Imaging
n Ultrasound
© 2002 National Semiconductor Corporation
DS200255
www.national.com