RF Agile Transceiver
Data Sheet
AD9363
FEATURES
FUNCTIONAL BLOCK DIAGRAM
RX1B_P,
RX1B_N
Radio frequency (RF) 2 × 2 transceiver with integrated 12-bit
DACs and ADCs
Wide bandwidth: 325 MHz to 3.8 GHz
Supports time division duplex (TDD) and frequency division
duplex (FDD) operation
AD9363
RX1A_P,
RX1A_N
ADC
RX1C_P,
RX1C_N
RX2B_P,
RX2B_N
P0_D11/
TX_D5_x TO P0_D0/
TX_D0_x
Tunable channel bandwidth (BW): up to 20 MHz
Receivers: 6 differential or 12 single-ended inputs
Superior receiver sensitivity with a noise figure: 3 dB
Receive (Rx) gain control
RX2A_P,
RX2A_N
ADC
RX2C_P,
RX2C_N
RX LO
TX LO
TX_MON1
P1_D11/
Real-time monitor and control signals for manual gain
Independent automatic gain control (AGC)
Dual transmitters: 4 differential outputs
Highly linear broadband transmitter
Transmit (Tx) error vector magnitude (EVM): −34 dB
Tx noise: ≤−157 dBm/Hz noise floor
Tx monitor: 66 dB dynamic range with 1 dB accuracy
Integrated fractional N synthesizers
2.4 Hz local oscillator (LO) step size
TX1A_P,
TX1A_N
DAC
DAC
RX_D5_x TO P1_D0/
RX_D0_x
TX1B_P,
TX1B_N
TX_MON2
TX2A_P,
TX2A_N
TX2B_P,
TX2B_N
RADIO
SWITCHING
GPO
SPI
CTRL
PLLs
CLK_OUT
CTRL
AUXADC AUXDACx
XTALN
CMOS/LVDS digital interface
NOTES
1. SPI, CTRL, P0_D11/TX_D5_x TO P0_D0/TX_D0_x, P1_D11/
RX_D5_x TO P1_D0/RX_D0_x, AND RADIO SWITCHING
CONTAIN MULTIPLE PINS.
APPLICATIONS
3G enterprise femtocell base stations
4G femtocell base stations
Figure 1.
Wireless video transmission
GENERAL DESCRIPTION
The AD9363 is a high performance, highly integrated RF agile
transceiver designed for use in 3G and 4G femtocell applications.
Its programmability and wideband capability make it ideal for a
broad range of transceiver applications. The device combines an
RF front end with a flexible mixed-signal baseband section and
integrated frequency synthesizers, simplifying design-in by
providing a configurable digital interface to a processor. The
AD9363 operates in the 325 MHz to 3.8 GHz range, covering
most licensed and unlicensed bands. Channel bandwidths from
less than 200 kHz to 20 MHz are supported.
sample rate.
The transmitters use a direct conversion architecture that achieves
high modulation accuracy with ultralow noise. This transmitter
design produces a best-in-class Tx EVM of −34 dB, allowing
significant system margin for the external power amplifier (PA)
selection. The on-board Tx power monitor can be used as a
power detector, enabling highly accurate Tx power
measurements.
The fully integrated phase-locked loops (PLLs) provide low
power fractional N frequency synthesis for all receive and
transmit channels. Channel isolation, demanded by FDD
systems, is integrated into the design. All voltage controlled
oscillators (VCOs) and loop filter components are integrated.
The two independent direct conversion receivers have state-of-
the-art noise figure and linearity. Each Rx subsystem includes
independent automatic gain control (AGC), dc offset correction,
quadrature correction, and digital filtering, thereby eliminating
the need for these functions in the digital baseband. The AD9363
also has flexible manual gain modes that can be externally
controlled. Two high dynamic range ADCs per channel digitize
the received I and Q signals and pass them through configurable
decimation filters and 128-tap finite impulse response (FIR)
filters to produce a 12-bit output signal at the appropriate
The core of the AD9363 can be powered directly from a 1.3 V
regulator. The IC is controlled via a standard 4-wire serial port
and four real-time I/O control pins. Comprehensive power-down
modes are included to minimize power consumption during
normal use. The AD9363 is packaged in a 10 mm × 10 mm,
144-ball chip scale package ball grid array (CSP_BGA).
Rev. D
Document Feedback
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rightsof third parties that may result fromits use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks andregisteredtrademarks are the property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
Technical Support
©2016 Analog Devices, Inc. All rights reserved.
www.analog.com
5秒后页面跳转
三星深化印度制造布局，供应链本地化进程加速
芯擎科技“星辰一号”自动驾驶芯片点亮成功，2025年量产在即
纳微科技震撼发布GaNSlim革新氮化镓功率芯片
意法半导体发布第四代SiC技术，助力电动汽车电驱
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
