5秒后页面跳转
AD8314ACP-EVALZ PDF预览

AD8314ACP-EVALZ

更新时间: 2024-11-28 01:19:39
品牌 Logo 应用领域
亚德诺 - ADI /
页数 文件大小 规格书
20页 522K
描述
RF Detector/Controller

AD8314ACP-EVALZ 数据手册

 浏览型号AD8314ACP-EVALZ的Datasheet PDF文件第2页浏览型号AD8314ACP-EVALZ的Datasheet PDF文件第3页浏览型号AD8314ACP-EVALZ的Datasheet PDF文件第4页浏览型号AD8314ACP-EVALZ的Datasheet PDF文件第5页浏览型号AD8314ACP-EVALZ的Datasheet PDF文件第6页浏览型号AD8314ACP-EVALZ的Datasheet PDF文件第7页 
100 MHz to 2.7 GHz, 45 dB  
RF Detector/Controller  
AD8314  
Data Sheet  
For convenience, the signal is internally ac-coupled, using a  
5 pF capacitor to a load of 3 kΩ in shunt with 2 pF. This high-  
pass coupling, with a corner at approximately 16 MHz,  
determines the lowest operating frequency. Therefore, the  
source can be dc grounded.  
FEATURES  
Complete RF detector/controller function  
Typical range:−58 dBV to −13 dBV  
−45 dBm to 0 dBm, re 50 Ω  
Frequency response from 100 MHz to 2.7 GHz  
Temperature-stable linear-in-dB response  
Accurate to 2.7 GHz  
Rapid response: 70 ns to a 10 dB step  
Low power: 12 mW at 2.7 V  
Power down to 20 µA  
The AD8314 provides two voltage outputs. The first, V_UP,  
increases from close to ground to about 1.2 V as the input signal  
level increases from 1.25 mV to 224 mV. This output is intended  
for use in measurement mode. Consult the Applications section  
for information on this mode. A capacitor can be connected  
between the V_UP and FLTR pins when it is desirable to  
increase the time interval over which averaging of the input  
waveform occurs.  
APPLICATIONS  
Cellular handsets (TDMA, CDMA , GSM)  
RSSI and TSSI for wireless terminal devices  
Transmitter power measurement and control  
The second output, V_DN, is an inversion of V_UP but with  
twice the slope and offset by a fixed amount. This output starts  
at about 2.25 V (provided the supply voltage is ≥3.3 V) for the  
minimum input and falls to a value close to ground at the  
maximum input. This output is intended for analog control  
loop applications. A setpoint voltage is applied to VSET, and  
V_DN is then used to control a VGA or power amplifier. Here  
again, an external filter capacitor can be added to extend the  
averaging time. Consult the Applications section for  
information on this mode.  
GENERAL DESCRIPTION  
The AD8314 is a complete low cost subsystem for the  
measurement and control of RF signals in the frequency range  
of 100 MHz to 2.7 GHz, with a typical dynamic range of 45 dB,  
intended for use in a wide variety of cellular handsets and other  
wireless devices. It provides a wider dynamic range and better  
accuracy than possible using discrete diode detectors. In  
particular, its temperature stability is excellent over the full  
operating range of −40°C to +85°C.  
The AD8314 is available in 8-lead MSOP and 8-lead LFCSP  
packages and consumes 4.5 mA from a 2.7 V to 5.5 V supply.  
When powered down, the typical sleep current is 20 µA.  
Its high sensitivity allows control at low power levels, thus  
reducing the amount of power that needs to be coupled to the  
detector. It is essentially a voltage-responding device, with a  
typical signal range of 1.25 mV to 224 mV rms or –58 dBV to  
−13 dBV. This is equivalent to −45 dBm to 0 dBm, re 50 Ω.  
FUNCTIONAL BLOCK DIAGRAM  
FLTR  
V-I  
VSET  
V_UP  
+
I-V  
DET  
DET  
DET  
DET  
DET  
+
X2  
V_DN  
RFIN  
10dB  
10dB  
10dB  
10dB  
VPOS  
ENBL  
BAND GAP  
REFERENCE  
OFFSET  
COMPENSATION  
AD8314  
COMM  
(PADDLE)  
Figure 1.  
Rev. C  
Document Feedback  
Information furnished by Analog Devices is believed to be accurate and reliable. However, no  
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other  
rightsof third parties that may result fromits use. Specifications subject to change without notice. No  
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.  
Trademarks andregisteredtrademarks are the property of their respective owners.  
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.  
Tel: 781.329.4700 ©2002–2018 Analog Devices, Inc. All rights reserved.  
Technical Support  
www.analog.com  
 
 
 
 

AD8314ACP-EVALZ 替代型号

型号 品牌 替代类型 描述 数据表
AD8314-EVAL ADI

完全替代

100 MHz-2500 MHz 45 dB RF Detector/Controller

与AD8314ACP-EVALZ相关器件

型号 品牌 获取价格 描述 数据表
AD8314ACP-REEL ADI

获取价格

100 MHz to 2.7 GHz, 45 dB RF Detector/Controller
AD8314ACP-REEL7 ADI

获取价格

100 MHz to 2.7 GHz, 45 dB RF Detector/Controller
AD8314ACP-WP ADI

获取价格

100 MHz to 2.7 GHz, 45 dB RF Detector/Controller
AD8314ACPZ ADI

获取价格

100 MHz to 2.7 GHz, 45 dB RF Detector/Controller
AD8314ACPZ-REEL ADI

获取价格

100 MHz to 2.7 GHz, 45 dB RF Detector/Controller
AD8314ACPZ-REEL7 ADI

获取价格

IC SPECIALTY TELECOM CIRCUIT, DSO8, 2 X 3 MM, LFCSP-8, Telecom IC:Other
AD8314ACPZ-RL7 ADI

获取价格

100 MHz to 2.7 GHz, 45 dB RF Detector/Controller
AD8314ARM ADI

获取价格

100 MHz-2500 MHz 45 dB RF Detector/Controller
AD8314ARM-REEL ADI

获取价格

100 MHz-2500 MHz 45 dB RF Detector/Controller
AD8314ARM-REEL7 ADI

获取价格

100 MHz-2500 MHz 45 dB RF Detector/Controller