5秒后页面跳转
ADM1170-1AUJZ-RL7 PDF预览

ADM1170-1AUJZ-RL7

更新时间: 2024-02-08 06:11:21
品牌 Logo 应用领域
亚德诺 - ADI 电源电路电源管理电路软启动光电二极管控制器
页数 文件大小 规格书
16页 253K
描述
1.6 V to 16.5 V Hot Swap Controller with Soft Start

ADM1170-1AUJZ-RL7 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Active零件包装代码:TSSOP
包装说明:VSSOP,针数:8
Reach Compliance Code:unknown风险等级:5.33
其他特性:UNDERVOLTAGE LOCKOUT可调阈值:NO
模拟集成电路 - 其他类型:POWER SUPPLY SUPPORT CIRCUITJESD-30 代码:R-PDSO-G8
JESD-609代码:e4长度:2.9 mm
湿度敏感等级:1信道数量:1
功能数量:1端子数量:8
最高工作温度:85 °C最低工作温度:-40 °C
封装主体材料:PLASTIC/EPOXY封装代码:VSSOP
封装形状:RECTANGULAR封装形式:SMALL OUTLINE, VERY THIN PROFILE, SHRINK PITCH
峰值回流温度(摄氏度):260座面最大高度:1 mm
最大供电电压 (Vsup):16.5 V最小供电电压 (Vsup):2.7 V
标称供电电压 (Vsup):5 V表面贴装:YES
温度等级:INDUSTRIAL端子面层:NICKEL PALLADIUM GOLD
端子形式:GULL WING端子节距:0.65 mm
端子位置:DUAL处于峰值回流温度下的最长时间:40
宽度:1.6 mmBase Number Matches:1

ADM1170-1AUJZ-RL7 数据手册

 浏览型号ADM1170-1AUJZ-RL7的Datasheet PDF文件第2页浏览型号ADM1170-1AUJZ-RL7的Datasheet PDF文件第3页浏览型号ADM1170-1AUJZ-RL7的Datasheet PDF文件第4页浏览型号ADM1170-1AUJZ-RL7的Datasheet PDF文件第5页浏览型号ADM1170-1AUJZ-RL7的Datasheet PDF文件第6页浏览型号ADM1170-1AUJZ-RL7的Datasheet PDF文件第7页 
1.6 V to 16.5 V Hot Swap Controller  
with Soft Start  
ADM1170  
FEATURES  
GENERAL DESCRIPTION  
Controls supply rails from 1.6 V to 16.5 V  
Supply voltage range from 2.7 V to 16.5 V  
Allows protected board removal and insertion to a live  
backplane  
External sense resistor provides adjustable analog current  
limit with circuit breaker  
Soft start controls inrush current profile  
Peak fault current limited with fast response  
Charge pumped gate drive for external N-FET switch  
Automatic retry or latch-off during current fault  
Undervoltage lockout  
The ADM1170 is a hot swap controller that safely enables a  
printed circuit board to be removed and inserted to a live  
backplane. This is achieved using an external N-channel power  
MOSFET with a current control loop that monitors the load  
current through a sense resistor. An internal charge pump is  
used to enhance the gate of the N-channel FET. When an  
overcurrent condition is detected, the gate voltage of the FET is  
reduced to limit the current flowing through the sense resistor.  
The ADM1170 operates with a supply voltage ranging from  
2.7 V to 16.5 V. By using independent SENSE pins from VCC  
,
8-lead, TSOT package  
the ADM1170 allows for the hot swap of supplies ranging down  
to 1.6 V. During an overcurrent condition, the TIMER pin  
capacitor determines the amount of time the FET remains at  
a current limiting mode of operation until it is shut down. The  
APPLICATIONS  
Hot swap board insertion: line cards, raid systems  
Industrial high-side switches/circuit breakers  
Electronic circuit breakers  
CLR  
ON (ON-  
) pin is the enable input for the device and can be  
used to monitor the input supply voltage. The ADM1170 also  
features soft start to provide the user with a capacitor program-  
mable ramping reference to the internal current sense comparator.  
This provides a linearly increasing current limit at startup at a  
rate set by CSS. This helps to reduce and limit large inrush  
currents.  
This device is available in two options: the ADM1170-1 with  
automatic retry for overcurrent fault and the ADM1170-2 with  
CLR  
latch-off for an overcurrent fault. Toggling the ON (ON-  
)
pin resets a latched fault. The ADM1170 is packaged in an  
8-lead TSOT.  
FUNCTIONAL BLOCK DIAGRAM  
R
SENSE  
Q
LONG  
1
V
= 1.8V  
V
= 1.8V  
OUT  
IN  
C
LOAD  
SENSE+ SENSE–  
LONG  
V
= 3.3VAUX  
IN  
V
CC  
GATE  
ADM1170-1  
ON  
R
ON1  
SHORT  
SS  
R
ON2  
C
SS  
TIMER  
GND  
C
TIMER  
GND  
LONG  
GND  
Figure 1.  
Rev. 0  
Information furnished by Analog Devices is believed to be accurate and reliable. However, no  
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other  
rights of third parties that may result from its use. Specifications subject to change without notice. No  
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.  
Trademarks and registeredtrademarks arethe property of their respective owners.  
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.  
Tel: 781.329.4700  
Fax: 781.461.3113  
www.analog.com  
©2006 Analog Devices, Inc. All rights reserved.  
 

与ADM1170-1AUJZ-RL7相关器件

型号 品牌 描述 获取价格 数据表
ADM1170-2AUJ ADI IC 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8, TSOT-8, Power Management Circuit

获取价格

ADM1170-2AUJZ-RL7 ADI 1.6 V to 16.5 V Hot Swap Controller with Soft Start

获取价格

ADM1171 ADI 2.7 V to 16.5 V Hot Swap Controller with Current Sense Output

获取价格

ADM1171-1AUJ ADI IC 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8, TSOT-8, Power Management Circuit

获取价格

ADM1171-1AUJZ-RL7 ADI 2.7 V to 16.5 V Hot Swap Controller with Current Sense Output

获取价格

ADM1171-2AUJ ADI IC 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8, TSOT-8, Power Management Circuit

获取价格