5秒后页面跳转
AD5235BRUZ250 PDF预览

AD5235BRUZ250

更新时间: 2024-01-22 06:18:29
品牌 Logo 应用领域
亚德诺 - ADI 转换器数字电位计电阻器光电二极管
页数 文件大小 规格书
32页 788K
描述
Nonvolatile Memory, Dual 1024-Position Digital Potentiometer

AD5235BRUZ250 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Active零件包装代码:TSSOP
包装说明:TSSOP,针数:16
Reach Compliance Code:unknown风险等级:5.78
Is Samacsys:N其他特性:LINEAR OR LOG TAPER SETTINGS; NONVOLATILE MEMORY; CAN ALSO OPERATE FROM +/-2.25V TO +/-2.75V SUPPLY
标称带宽:0.125 kHz控制接口:3-WIRE SERIAL
转换器类型:DIGITAL POTENTIOMETERJESD-30 代码:R-PDSO-G16
JESD-609代码:e3长度:5 mm
湿度敏感等级:3功能数量:2
位置数:1024端子数量:16
最高工作温度:85 °C最低工作温度:-40 °C
封装主体材料:PLASTIC/EPOXY封装代码:TSSOP
封装形状:RECTANGULAR封装形式:SMALL OUTLINE, THIN PROFILE, SHRINK PITCH
峰值回流温度(摄氏度):260认证状态:COMMERCIAL
电阻定律:LOGARITHMIC最大电阻容差:30%
最大电阻器端电压:5 V最小电阻器端电压:
座面最大高度:1.2 mm标称供电电压:5 V
表面贴装:YES标称温度系数:35 ppm/ °C
温度等级:INDUSTRIAL端子面层:MATTE TIN
端子形式:GULL WING端子节距:0.65 mm
端子位置:DUAL处于峰值回流温度下的最长时间:40
标称总电阻:250000 Ω宽度:4.4 mm
Base Number Matches:1

AD5235BRUZ250 数据手册

 浏览型号AD5235BRUZ250的Datasheet PDF文件第2页浏览型号AD5235BRUZ250的Datasheet PDF文件第3页浏览型号AD5235BRUZ250的Datasheet PDF文件第4页浏览型号AD5235BRUZ250的Datasheet PDF文件第5页浏览型号AD5235BRUZ250的Datasheet PDF文件第6页浏览型号AD5235BRUZ250的Datasheet PDF文件第7页 
Nonvolatile Memory, Dual  
1024-Position Digital Potentiometer  
AD5235  
Data Sheet  
FEATURES  
FUNCTIONAL BLOCK DIAGRAM  
Dual-channel, 1024-position resolution  
25 kΩ, 250 kΩ nominal resistance  
Maximum 8% nominal resistor tolerance error  
Low temperature coefficient: 35 ppm/°C  
2.7 V to 5 V single supply or 2.5 V dual supply  
SPI-compatible serial interface  
Nonvolatile memory stores wiper settings  
Power-on refreshed with EEMEM settings  
Permanent memory write protection  
Resistance tolerance stored in EEMEM  
26 bytes extra nonvolatile memory for user-defined  
information  
AD5235  
V
ADDR  
DECODE  
DD  
RDAC1  
REGISTER  
CS  
CLK  
SDI  
A1  
W1  
SERIAL  
INTERFACE  
B1  
RDAC1  
RDAC2  
SDO  
EEMEM1  
POWER-ON  
RESET  
PR  
RDAC2  
REGISTER  
A2  
WP  
EEMEM  
CONTROL  
W2  
RDY  
B2  
EEMEM2  
V
SS  
26 BYTES  
USER EEMEM  
RTOL*  
GND  
1M programming cycles  
100-year typical data retention  
*RAB TOLERANCE  
APPLICATIONS  
Figure 1.  
DWDM laser diode driver, optical supervisory systems  
Mechanical potentiometer replacement  
Instrumentation: gain, offset adjustment  
Programmable voltage-to-current conversion  
Programmable filters, delays, time constants  
Programmable power supply  
In the scratchpad programming mode, a specific setting can  
be programmed directly to the RDAC2 register, which sets the  
resistance between Terminal W and Terminal A and Terminal W  
and Terminal B. This setting can be stored into the EEMEM  
and is restored automatically to the RDAC register during  
system power-on.  
Low resolution DAC replacement  
Sensor calibration  
The EEMEM content can be restored dynamically or through  
PR  
WP  
external  
strobing, and a  
function protects EEMEM  
GENERAL DESCRIPTION  
contents. To simplify the programming, the independent or  
simultaneous linear-step increment or decrement commands  
can be used to move the RDAC wiper up or down, one step at  
a time. For logarithmic 6 dB changes in the wiper setting, the  
left or right bit shift command can be used to double or halve the  
RDAC wiper setting.  
The AD5235 is a dual-channel, nonvolatile memory,1 digitally  
controlled potentiometer2 with 1024-step resolution, offering  
guaranteed maximum low resistor tolerance error of 8%.  
The device performs the same electronic adjustment function  
as a mechanical potentiometer with enhanced resolution, solid  
state reliability, and superior low temperature coefficient per-  
formance. The versatile programming of the AD5235 via an  
SPI®-compatible serial interface allows 16 modes of operation  
and adjustment including scratchpad programming, memory  
storing and restoring, increment/decrement, 6 dB/step log taper  
adjustment, wiper setting readback, and extra EEMEM1 for user-  
defined information such as memory data for other components,  
look-up table, or system identification information.  
The AD5235 patterned resistance tolerance is stored in the  
EEMEM. The actual end-to-end resistance can, therefore, be  
known by the host processor in readback mode. The host can  
execute the appropriate resistance step through a software  
routine that simplifies open-loop applications as well as  
precision calibration and tolerance matching applications.  
The AD5235 is available in a thin, 16-lead TSSOP package.  
The part is guaranteed to operate over the extended industrial  
temperature range of −40°C to +85°C.  
1 The terms nonvolatile memory and EEMEM are used interchangeably.  
2 The terms digital potentiometer and RDAC are used interchangeably.  
Rev. F  
Information furnished by Analog Devices is believed to be accurate and reliable. However, no  
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other  
rights of third parties that may result fromits use. Specifications subject to change without notice. No  
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.  
Trademarks andregisteredtrademarks are the property of their respective owners.  
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.  
Tel: 781.329.4700  
www.analog.com  
Fax: 781.461.3113 ©2004–2012 Analog Devices, Inc. All rights reserved.  
 
 
 
 
 
 

与AD5235BRUZ250相关器件

型号 品牌 描述 获取价格 数据表
AD5235-EP ADI Nonvolatile Memory, Dual 1024-Position Digital Potentiometer

获取价格

AD524 ADI Precision Instrumentation Amplifier

获取价格

AD524_07 ADI Precision Instrumentation Amplifier

获取价格

AD524_16 ADI Precision Instrumentation Amplifier

获取价格

AD5240 ADI FAST, COMPLETE 12-BIT A/D CONVERTERS

获取价格

AD5240BD ETC Analog-to-Digital Converter, 12-Bit

获取价格