5秒后页面跳转
ACT4487-DI PDF预览

ACT4487-DI

更新时间: 2024-01-28 10:35:20
品牌 Logo 应用领域
艾法斯 - AEROFLEX 电信集成电路
页数 文件大小 规格书
7页 102K
描述
ACT 4487 DUAL TRANSCEIVER FOR MIL-STD-1553/1760

ACT4487-DI 技术参数

生命周期:TransferredReach Compliance Code:unknown
风险等级:5.74Is Samacsys:N
差分输出:YES驱动器位数:1
高电平输入电流最大值:0.00004 AJESD-30 代码:R-PDIP-T24
端子数量:24最高工作温度:125 °C
最低工作温度:-55 °C最大输出低电流:0.004 A
封装主体材料:PLASTIC/EPOXY封装代码:DIP
封装等效代码:DIP24,.6封装形状:RECTANGULAR
封装形式:IN-LINE电源:5,+-15 V
认证状态:Not Qualified最大接收延迟:400 ns
筛选级别:38535Q/M;38534H;883B子类别:Line Driver or Receivers
最大压摆率:200 mA表面贴装:NO
技术:TTL温度等级:MILITARY
端子形式:THROUGH-HOLE端子节距:2.54 mm
端子位置:DUALBase Number Matches:1

ACT4487-DI 数据手册

 浏览型号ACT4487-DI的Datasheet PDF文件第2页浏览型号ACT4487-DI的Datasheet PDF文件第3页浏览型号ACT4487-DI的Datasheet PDF文件第4页浏览型号ACT4487-DI的Datasheet PDF文件第5页浏览型号ACT4487-DI的Datasheet PDF文件第6页浏览型号ACT4487-DI的Datasheet PDF文件第7页 
ACT 4487 DUAL TRANSCEIVER  
FOR MIL-STD-1553/1760  
CIRCUIT TECHNOLOGY  
Features  
www.aeroflex.com/act1.htm  
• +5 / ±15 Volt Supply Operation  
• Low Power Dissipation  
General Description  
The  
Aeroflex  
Circuit  
• Small Size & Light Weight  
Technology ACT 4487 is a next  
generation monolithic transceiver  
• Dual Transceivers Saves Space & Cost  
• Outstanding MIL-STD-1553 performance  
design  
which  
provides  
full  
compliance to MIL-STD-1553A/B  
and 1760 requirements in a small  
package  
consumption.  
The ACT 4487 series performs  
the front-end analog function of  
inputting and outputting data  
with  
low  
power  
• Radiation Hard Dielectric Isolation Monolithic  
Construction for Severe Environments  
• Superior High Frequency Line Transient and  
Input Ripple Rejection  
through  
a
transformer to the  
MIL-STD-1553 data bus.  
• Input and Output TTL Compatible Design  
Design of this transceiver reflects  
particular attention to active filter  
performance. This results in low bit  
and word error rate with superior  
waveform purity and minimal zero  
• Processed and Screened to MIL-STD-883 Specs  
• MIL-PRF-38534 Compliant Devices Available  
• DESC SMD (Standard Military Drawing)  
crossover  
distortion.  
Efficient  
transmitter electrical and thermal  
design provides low internal power  
dissipation and heat rise at high as  
well as low duty cycles.  
Each channel of the dual  
transceiver is completely separate  
TX DATA OUT  
TX DATA OUT  
TX DATA IN  
from  
the  
other  
and  
fully  
ACTIVE  
FILTER  
OUTPUT  
STAGE  
DRIVER  
TX DATA IN  
independent. This includes power  
leads as well as signal lines.  
Hence, each channel may be  
connected to a different data bus  
with no interaction.  
TX INHIBIT IN  
+5V (VL)  
+15V (VCC)  
-15V (VEE)  
GND1  
RX DATA OUT  
REFERENCE  
COMP.  
COMP.  
GND2  
Transmitter:  
GND3  
RX DATA OUT  
RX DATA IN  
RX DATA IN  
CASE  
INPUT  
AMPLIFIER  
ACTIVE  
FILTER  
The Transmitter section accepts  
bi-phase TTL data at the input and  
when coupled to the data bus with a  
1.4:1 ratio transformer, isolated on  
the data bus side with two 52.5  
Ohm fault isolation resistors, and  
RX STROBE IN  
Block Diagram (Without Transformer)  
loaded  
by  
two  
70  
Ohm  
eroflex Circuit Technology – Data Bus Modules For The Future © SCD4487D REV B 3/10/98  

与ACT4487-DI相关器件

型号 品牌 描述 获取价格 数据表
ACT4489 AEROFLEX ACT 4489 SINGLE TRANSCEIVER FOR MIL-STD-1553/1760

获取价格

ACT4489111111 AEROFLEX ACT 4489 DUAL TRANSCEIVER FOR MIL-STD-1553/1760

获取价格

ACT4489-D AEROFLEX ACT 4489 DUAL TRANSCEIVER FOR MIL-STD-1553/1760

获取价格

ACT4489-DF AEROFLEX ACT 4489 DUAL TRANSCEIVER FOR MIL-STD-1553/1760

获取价格

ACT4489-DFI AEROFLEX ACT 4489 DUAL TRANSCEIVER FOR MIL-STD-1553/1760

获取价格

ACT4489-DI AEROFLEX ACT 4489 DUAL TRANSCEIVER FOR MIL-STD-1553/1760

获取价格