5秒后页面跳转
ACT4468D PDF预览

ACT4468D

更新时间: 2024-02-14 14:38:17
品牌 Logo 应用领域
艾法斯 - AEROFLEX 驱动器
页数 文件大小 规格书
6页 84K
描述
ACT4468D Dual Transceivers for MIL-STD-1553

ACT4468D 技术参数

是否Rohs认证: 不符合生命周期:Active
包装说明:DIP,Reach Compliance Code:unknown
HTS代码:8542.39.00.01风险等级:5.51
Is Samacsys:NJESD-30 代码:R-XDIP-T20
JESD-609代码:e0长度:25.4 mm
功能数量:2端子数量:20
最高工作温度:125 °C最低工作温度:-55 °C
封装主体材料:UNSPECIFIED封装代码:DIP
封装形状:RECTANGULAR封装形式:IN-LINE
认证状态:Not Qualified筛选级别:MIL-STD-883
座面最大高度:4.2418 mm标称供电电压:5 V
表面贴装:NO电信集成电路类型:MIL-STD-1553 DATA BUS TRANSCEIVER
温度等级:MILITARY端子面层:Tin/Lead (Sn/Pb)
端子形式:THROUGH-HOLE端子节距:2.54 mm
端子位置:DUAL宽度:7.62 mm
Base Number Matches:1

ACT4468D 数据手册

 浏览型号ACT4468D的Datasheet PDF文件第2页浏览型号ACT4468D的Datasheet PDF文件第3页浏览型号ACT4468D的Datasheet PDF文件第4页浏览型号ACT4468D的Datasheet PDF文件第5页浏览型号ACT4468D的Datasheet PDF文件第6页 
ACT4468D  
Dual Transceivers for MIL-STD-1553  
Features  
CIRCUIT TECHNOLOGY  
• World’s smallest and lowest standby power dual  
transceiver 0.3" x 1" packages  
www.aeroflex.com  
General Description  
• Dual transceiver meets military data bus  
The Aeroflex Circuit Technology  
requirements, MIL-STD-1553 and MIL-STD-1760  
• Low power dissipation at full output power  
• Single +5V power supply  
Model ACT4468D is  
a
next  
generation D.I. monolithic transceiver  
which provide full compliance with  
MIL-STD-1553/1760 and data bus  
requirements  
in  
the  
smallest  
• Current source output  
• Monolithic construction using dielectrically  
isolated(D.I.)  
packages with the lowest standby  
power consumption and one power  
supply operation.  
The dual channel Model ACT4468D  
perform the front-end analog function  
of inputting and outputting data  
• Processed and screened to MIL-STD-883 specs  
• DESC SMD# 5962–92061 Pending  
through  
a
transformer  
to  
a
MIL-STD-1553/1760 data bus.  
Design of these transceivers reflects  
particular attention to active filter  
performance. This results in low bit  
and word error rate with superior  
waveform purity and minimal zero  
crossover  
distortion.  
Efficient  
transmitter electrical and thermal  
design provides low internal power  
dissipation and heat rise at high as  
well as low duty cycles.  
Each channel of the dual transceiver  
is completely separate from the other  
and fully independent. This includes  
power leads as well as signal lines.  
Hence, each channel may be  
connected to a different data bus with  
no interaction.  
ACT4468D Dual Transceiver  
TX/RX  
TX DATA IN  
Transmitter:  
OUTPUT  
STAGE  
DRIVER  
SHAPING  
TX/RX  
TX DATA IN  
The Transmitter section accepts  
bi-phase TTL data at the input and  
when coupled to the data bus with a  
1:2.5 transformer, isolated on the  
data bus side with two 52.5 Ohm fault  
isolation resistors, and loaded by two  
70 Ohm terminations plus additional  
receivers, the data bus signal  
produced is 7.5Volts nominal P-P at  
A-A’. (See Figure 5.) When both  
DATA and DATA inputs are held low or  
high, the transmitter output becomes  
TX INHIBIT  
RX DATA OUT  
COMP.  
COMP.  
+5 V  
REFERENCE  
GROUND  
RX DATA OUT  
ACTIVE  
FILTER  
INPUT  
AMP  
STROBE  
Block Diagram (without Transformer), 1/2 of unit shown  
eroflex Circuit Technology – Data Bus Modules For The Future © SCD4468D REV B 5/25/00  

与ACT4468D相关器件

型号 品牌 描述 获取价格 数据表
ACT4468DF AEROFLEX ACT4468D Dual Transceivers for MIL-STD-1553

获取价格

ACT4468DFI AEROFLEX ACT4468D Dual Transceivers for MIL-STD-1553

获取价格

ACT4468DI AEROFLEX ACT4468D Dual Transceivers for MIL-STD-1553

获取价格

ACT4469D AEROFLEX Dual Variable Amplitude Transceivers for H009

获取价格

ACT4469DI AEROFLEX Dual Variable Amplitude Transceivers for H009

获取价格

ACT4480-DFI AEROFLEX ACT4480-DFI Dual Transceiver

获取价格