5秒后页面跳转
ACT4438 PDF预览

ACT4438

更新时间: 2022-11-29 04:06:46
品牌 Logo 应用领域
艾法斯 - AEROFLEX /
页数 文件大小 规格书
7页 152K
描述
ACT4438-1 Transceiver for MIL-STD-1553 / 1760 in a Chipscale Package

ACT4438 数据手册

 浏览型号ACT4438的Datasheet PDF文件第2页浏览型号ACT4438的Datasheet PDF文件第3页浏览型号ACT4438的Datasheet PDF文件第4页浏览型号ACT4438的Datasheet PDF文件第5页浏览型号ACT4438的Datasheet PDF文件第6页浏览型号ACT4438的Datasheet PDF文件第7页 
ACT4438–1  
Transceiver for MIL-STD-1553/ 1760  
in a Chipscale Package  
Preliminary  
CIRCUIT TECHNOLOGY  
Features  
www.aeroflex.com  
Transceiver meets military data bus requirements,  
MIL-STD-1553 and MIL-STD-1760  
• Low power dissipation at full output power  
• Single +5V power supply  
• Current Source Transmitter Output  
• Bipolar Monolithic Construction  
• Miniature Chipscale Package Bumped Chip Carrier™  
General Description  
The Aeroflex Circuit Technology  
Model ACT4438-1 is  
a
next  
generation monolithic transceiver  
which provide full compliance with  
MIL-STD-1553/1760 and data bus  
requirements in a Bumped Chip  
Carrier™ (BCC++) with the lowest  
standby power consumption and  
single power supply operation.  
(BCC++)  
The Model ACT4438-1 performs the  
front-end analog function of inputting  
and outputting data through  
a
transformer to a MIL-STD-1553/1760  
Shown 2X  
data bus with  
components.  
a
few external  
Design of these transceivers reflects  
particular attention to active filter  
performance. This results in low bit  
and word error rate with superior  
waveform purity and minimal zero  
crossover  
distortion.  
Efficient  
transmitter electrical and thermal  
design provides low internal power  
dissipation and heat rise at high as  
well as low duty cycles.  
NOTE: BCC++ and Bumped Chip Carrier are Trademarks of Fujitsu Ltd.  
Transmitter  
Block Diagram (without Transformer)  
The Transmitter section accepts  
bi-phase TTL data at the input and  
when coupled to the data bus with a  
1:2.5 transformer, isolated on the  
data bus side with two 55 Ohm fault  
isolation resistors for direct stub  
coupling. The data bus signal  
produced for RISET = 2.7K Ohm is  
typically 7.5 Volts nominal P-P at  
A-A’, See Figure 5. When both DATA  
and DATA inputs are held low, the  
transmitter output becomes a high  
impedance and is “removed” from the  
line. In addition, an overriding  
“INHIBIT" input provides for the  
removal of the transmitter output from  
the line. A logic “1” applied to the  
“INHIBIT” takes priority over the  
TX DATA OUT  
TX DATA IN  
OUTPUT  
STAGE  
DRIVER  
SHAPING  
TX DATA OUT  
TX DATA IN  
TX INHIBIT  
RISET  
RX DATA OUT  
COMP.  
COMP.  
REFERENCE  
+5 V  
GROUND  
RX DATA IN  
RX DATA IN  
RX DATA OUT  
ACTIVE  
FILTER  
INPUT  
AMP  
STROBE  
eroflex Circuit Technology – Data Bus Modules For The Future © SCD4438-1 REV A 11/19/01  

与ACT4438相关器件

型号 品牌 描述 获取价格 数据表
ACT4438? AEROFLEX Transceiver for MIL-STD-1553 / MIL-STD-1760 in a Chipscale Package

获取价格

ACT4438-1 AEROFLEX ACT4438-1 Transceiver for MIL-STD-1553 / 1760 in a Chipscale Package

获取价格

ACT4440N AEROFLEX Single Transceiver for MACAIR (A3818, A4905, A5232, A5690), MIL-STD-1553 & SAE-AS15531

获取价格

ACT4440N-2 AEROFLEX Single Transceiver for MACAIR (A3818, A4905, A5232, A5690), MIL-STD-1553 & SAE-AS15531

获取价格

ACT4444 AEROFLEX Transceiver for MIL-STD-1553 /MACAIR in a Chipscale Package

获取价格

ACT4453 AEROFLEX ACT 4453 / 4463 SINGLE SUPPLY TRANSCEIVERS FOR MIL-STD-1553/1760

获取价格