5秒后页面跳转
ACT4418D PDF预览

ACT4418D

更新时间: 2024-02-04 11:13:56
品牌 Logo 应用领域
艾法斯 - AEROFLEX 电信集成电路光电二极管
页数 文件大小 规格书
7页 78K
描述
ACT4418 Molded Dual Variable Amplitude Transceivers for MACAIR A3818, A5690, A5232, A4905 & MIL-STD-1553

ACT4418D 技术参数

生命周期:Active包装说明:DIP,
Reach Compliance Code:unknownHTS代码:8542.39.00.01
风险等级:5.64JESD-30 代码:S-XDIP-P24
负电源额定电压:-12 V功能数量:1
端子数量:24最高工作温度:125 °C
最低工作温度:-55 °C封装主体材料:UNSPECIFIED
封装代码:DIP封装形状:SQUARE
封装形式:IN-LINE认证状态:Not Qualified
座面最大高度:4.445 mm标称供电电压:12 V
表面贴装:NO电信集成电路类型:MIL-STD-1553 DATA BUS TRANSCEIVER
温度等级:MILITARY端子形式:PIN/PEG
端子节距:2.54 mm端子位置:DUAL
宽度:27.94 mmBase Number Matches:1

ACT4418D 数据手册

 浏览型号ACT4418D的Datasheet PDF文件第2页浏览型号ACT4418D的Datasheet PDF文件第3页浏览型号ACT4418D的Datasheet PDF文件第4页浏览型号ACT4418D的Datasheet PDF文件第5页浏览型号ACT4418D的Datasheet PDF文件第6页浏览型号ACT4418D的Datasheet PDF文件第7页 
ACT4418 Molded Dual Variable Amplitude Transceivers  
for MACAIR A3818, A5690, A5232, A4905  
& MIL-STD-1553  
Features  
CIRCUIT TECHNOLOGY  
www.aeroflex.com/act1.htm  
• ACT4418 Dual Transceivers meets  
MIL-STD-1553A&B, Macair A3818,  
A4905, A5232 and A5690 Specs  
General Description  
The Aeroflex Circuit Technology  
ACT4418D is a new generation  
monolithic transceivers which provide  
full compliance with Macair and MIL-  
• ±12 Volt Power Supply Operation  
STD-1553 data bus requirements  
while providing variable amplitude  
• Voltage source output for higher bus  
drive power  
control.  
The ACT4418D performs the front-  
end analog function of inputting and  
outputting data through a transformer  
to a MIL-STD-1553 or Macair data  
bus. The ACT4418D can be consid-  
ered a "Universal" Transceiver in that  
it is compatible with MIL-STD-1553A,  
B, Macair A-3818, A-4905, A-5232  
and A-5690.  
• Molded Plug-in package  
• Monolithic construction using linear  
ASICs  
• Variable TX Amplitude  
Design of these transceivers  
reflects particular attention to active  
filter performance.This results in low  
bit and word error rate with superior  
waveform purity and minimal zero  
crossover distortion. The ACT4418D  
active filter design has additional high  
frequency roll-off to provide the  
required Macair low harmonic  
• Processed and Screened to Mil-STD-883  
Specs for Industrial temperature range  
distortion  
increasing  
characteristics significantly.  
waveform  
the pulse  
without  
delay  
One Channel  
TX DATA OUT  
TX DATA OUT  
TX DATA IN  
TX DATA IN  
OUTPUT  
STAGE  
DRIVER  
SHAPING  
Efficient transmitter electrical and  
thermal design provides low internal  
power dissipation and heat rise at  
high and well as low duty cycles.  
V+  
TX INHIBIT  
AMP CONTROL  
RX DATA OUT  
COMP.  
COMP.  
Variable amplitude is adjusted with  
0–10 Vdc on the control pin.  
+5V  
-12V  
V-  
GROUND  
RX DATA IN  
RX DATA OUT  
ACTIVE  
FILTER  
INPUT  
AMP  
RX DATA IN  
Transmitter:  
+12V  
The Transmitter section accepts bi-  
phase TTL data at the input and  
when coupled to the data bus with a  
1:1 transformer, isolated on the data  
bus side with two 52.5 Ohm fault iso-  
lation resistors, and loaded by two 70  
STROBE  
Block Diagram (without Transformer)  
eroflex Circuit Technology – Data Bus Modules For The Future © SCD4418D REV A 9/24/97  

与ACT4418D相关器件

型号 品牌 描述 获取价格 数据表
ACT4419 AEROFLEX Single Supply Variable Amplitude Transceivers for MIL-STD-1553

获取价格

ACT4419D AEROFLEX Dual Variable Amplitude Transceivers for MIL-STD-1553

获取价格

ACT4419DF AEROFLEX Dual Variable Amplitude Transceivers for MIL-STD-1553

获取价格

ACT4419FP AEROFLEX Single Supply Variable Amplitude Transceivers for MIL-STD-1553

获取价格

ACT4423 AEROFLEX ACT4423 DUAL TRANSCEIVER FOR MIL-STD-1553/1760

获取价格

ACT4423-D AEROFLEX ACT4423 DUAL TRANSCEIVER FOR MIL-STD-1553/1760

获取价格