5秒后页面跳转
5962-9326101MEA PDF预览

5962-9326101MEA

更新时间: 2024-01-24 02:51:04
品牌 Logo 应用领域
德州仪器 - TI 稳压器开关式稳压器或控制器电源电路开关式控制器
页数 文件大小 规格书
12页 312K
描述
High Power Factor Preregulator

5962-9326101MEA 技术参数

生命周期:ObsoleteReach Compliance Code:unknown
风险等级:5.74Is Samacsys:N
模拟集成电路 - 其他类型:POWER FACTOR CONTROLLER控制模式:CURRENT-MODE
控制技术:PULSE WIDTH MODULATION最大输入电压:35 V
最小输入电压:11 VJESD-30 代码:R-GDIP-T16
功能数量:1端子数量:16
最高工作温度:125 °C最低工作温度:-55 °C
最大输出电流:1.5 A封装主体材料:CERAMIC, GLASS-SEALED
封装形状:RECTANGULAR封装形式:IN-LINE
认证状态:Not Qualified筛选级别:MIL-STD-883
表面贴装:NO切换器配置:SINGLE
最大切换频率:200 kHz技术:BIPOLAR
温度等级:MILITARY端子形式:THROUGH-HOLE
端子位置:DUALBase Number Matches:1

5962-9326101MEA 数据手册

 浏览型号5962-9326101MEA的Datasheet PDF文件第2页浏览型号5962-9326101MEA的Datasheet PDF文件第3页浏览型号5962-9326101MEA的Datasheet PDF文件第4页浏览型号5962-9326101MEA的Datasheet PDF文件第5页浏览型号5962-9326101MEA的Datasheet PDF文件第6页浏览型号5962-9326101MEA的Datasheet PDF文件第7页 
UC1854  
UC2854  
UC3854  
High Power Factor Preregulator  
FEATURES  
DESCRIPTION  
Control Boost PWM to 0.99 Power Factor  
The UC1854 provides active power factor correction for power sys-  
tems that otherwise would draw non-sinusoidal current from sinusoi-  
dal power lines. This device implements all the control functions  
necessary to build a power supply capable of optimally using available  
power-line current while minimizing line-current distortion. To do this,  
the UC1854 contains a voltage amplifier, an analog multiplier/divider,  
a current amplifier, and a fixed-frequency PWM. In addition, the  
UC1854 contains a power MOSFET compatible gate driver, 7.5V ref-  
erence, line anticipator, load-enable comparator, low-supply detector,  
and over-current comparator.  
Limit Line Current Distortion To <5%  
World-Wide Operation Without Switches  
Feed-Forward Line Regulation  
Average Current-Mode Control  
Low Noise Sensitivity  
Low Start-Up Supply Current  
Fixed-Frequency PWM Drive  
Low-Offset Analog Multiplier/Divider  
1A Totem-Pole Gate Driver  
The UC1854 uses average current-mode control to accomplish fixed-  
frequency current control with stability and low distortion. Unlike peak  
current-mode, average current control accurately maintains sinusoidal  
line current without slope compensation and with minimal response to  
noise transients.  
The UC1854’s high reference voltage and high oscillator amplitude  
minimize noise sensitivity while fast PWM elements permit chopping  
frequencies above 200kHz. The UC1854 can be used in single and  
three phase systems with line voltages that vary from 75 to 275 volts  
and line frequencies across the 50Hz to 400Hz range. To reduce the  
burden on the circuitry that supplies power to this device, the UC1854  
features low starting supply current.  
Precision Voltage Reference  
These devices are available packaged in 16-pin plastic and ceramic  
dual in-line packages, and a variety of surface-mount packages.  
BLOCK DIAGRAM  
UDG-92055  
6/98  

与5962-9326101MEA相关器件

型号 品牌 描述 获取价格 数据表
5962-9326101MEX TI 1.5A POWER FACTOR CONTROLLER, 200kHz SWITCHING FREQ-MAX, CDIP16

获取价格

5962-9326102M2A TI ADVANCED HIGH-POWER FACTOR PREREGULATOR

获取价格

5962-9326102MEA TI ADVANCED HIGH-POWER FACTOR PREREGULATOR

获取价格

5962-9326102MEX TI 1.5A POWER FACTOR CONTROLLER, 200kHz SWITCHING FREQ-MAX, CDIP16

获取价格

5962-9326103M2A TI 1.5A POWER FACTOR CONTROLLER, 118kHz SWITCHING FREQ-MAX, CQCC20, CERAMIC, LCC-20

获取价格

5962-9326103MEA ETC Power Factor Controller

获取价格