5秒后页面跳转
CAT9532YI PDF预览

CAT9532YI

更新时间: 2024-02-24 09:07:15
品牌 Logo 应用领域
安森美 - ONSEMI 并行IO端口微控制器和处理器外围集成电路光电二极管
页数 文件大小 规格书
18页 382K
描述
16-bit Programmable LED Dimmer with I2C Interface

CAT9532YI 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Active零件包装代码:TSSOP
包装说明:TSSOP,针数:24
Reach Compliance Code:unknown风险等级:5.35
Is Samacsys:NJESD-30 代码:R-PDSO-G24
JESD-609代码:e3长度:7.8 mm
湿度敏感等级:1I/O 线路数量:16
端口数量:1端子数量:24
最高工作温度:85 °C最低工作温度:-40 °C
封装主体材料:PLASTIC/EPOXY封装代码:TSSOP
封装形状:RECTANGULAR封装形式:SMALL OUTLINE, THIN PROFILE, SHRINK PITCH
峰值回流温度(摄氏度):260认证状态:COMMERCIAL
座面最大高度:1.2 mm最大供电电压:5.5 V
最小供电电压:2.3 V表面贴装:YES
技术:CMOS温度等级:INDUSTRIAL
端子面层:MATTE TIN端子形式:GULL WING
端子节距:0.65 mm端子位置:DUAL
处于峰值回流温度下的最长时间:40宽度:4.4 mm
uPs/uCs/外围集成电路类型:PARALLEL IO PORT, GENERAL PURPOSEBase Number Matches:1

CAT9532YI 数据手册

 浏览型号CAT9532YI的Datasheet PDF文件第2页浏览型号CAT9532YI的Datasheet PDF文件第3页浏览型号CAT9532YI的Datasheet PDF文件第4页浏览型号CAT9532YI的Datasheet PDF文件第5页浏览型号CAT9532YI的Datasheet PDF文件第6页浏览型号CAT9532YI的Datasheet PDF文件第7页 
CAT9532  
16-bit Programmable LED Dimmer with I2C Interface  
FEATURES  
DESCRIPTION  
„ 16 LED drivers with dimming control  
„ 256 brightness steps  
The CAT9532 is a CMOS device that provides 16-bit  
parallel input/output port expander optimized for LED  
dimming control. The CAT9532 outputs can drive  
directly 16 LEDs in parallel. Each individual LED may  
be turned ON, OFF, or blinking at one of two  
programmable rates. The device provides a simple  
solution for dimming LEDs in 256 brightness steps for  
backlight and color mixing applications. The CAT9532  
is suitable in I2C and SMBus compatible applications  
where it is necessary to limit the bus traffic or free-up  
the bus master’s timer.  
„ 16 open drain outputs drive 25 mA each  
„ 2 selectable programmable blink rates:  
– frequency: 0.593Hz to 152Hz  
– duty cycle: 0% to 99.6%  
„ I/Os can be used as GPIOs  
„ 400kHz I2C bus compatible*  
„ 2.3V to 5.5V operation  
The CAT9532 contains an internal oscillator and two  
PWM signals that drive the LED outputs. The user can  
program the period and duty cycle for each individual  
PWM signal. After the initial set-up command to  
program the Blink Rate 1 and Blink Rate 2 (frequency  
and duty cycle), only one command from the bus master  
is required to turn each individual open drain output ON,  
OFF, or cycle at Blink Rate 1 or Blink Rate 2. Each  
open drain LED output can provide a maximum output  
current of 25mA. The total current sunk by all I/Os must  
not exceed 200mA.  
„ 5V tolerant I/Os  
„ Active low reset input  
„ RoHS-compliant 24-Lead SOIC, TSSOP and  
24-pad TQFN (4 x 4mm) packages  
APPLICATIONS  
„ Backlighting  
„ RGB color mixing  
„ Sensors control  
„ Power switches, push-buttons  
„ Alarm systems  
TYPICAL APPLICATION CIRCUIT  
For Ordering Information details, see page 17.  
5 V  
5 V  
3 x 10kΩ  
RS0  
RS1  
RS11  
V
CC  
SDA  
SDA  
SCL  
LED0  
LED1  
SCL  
RESET  
RESET  
CAT9532  
LED11  
2
I C/SMBus  
Master  
A2  
A1  
A0  
LED12  
GPIOs  
V
SS  
LED15  
* Catalyst Semiconductor is licensed by Philips Corporation to  
carry the I2C Protocol.  
Notes: LED0 to LED11 are used as LED drivers  
LED12 to LED15 are used as regular GPIOs  
© 2010 SCILLC. All rights reserved  
Characteristics subject to change without notice  
1
Doc. No. MD-9001 Rev. E  

与CAT9532YI相关器件

型号 品牌 描述 获取价格 数据表
CAT9532YI-T2 ONSEMI 16-bit Programmable LED Dimmer with I2C Interface

获取价格

CAT9534 ONSEMI 8-bit I²C and SMBus I/O Port with Interrupt

获取价格

CAT9534 CATALYST Catalyst Semiconductor

获取价格

CAT9534HV4I-G ONSEMI 8-bit I²C and SMBus I/O Port with Interrupt

获取价格

CAT9534HV4I-GT2 ONSEMI 8-bit I²C and SMBus I/O Port with Interrupt

获取价格

CAT9534WI-G ONSEMI 8-bit I²C and SMBus I/O Port with Interrupt

获取价格