5秒后页面跳转
T7906EKST/883 PDF预览

T7906EKST/883

更新时间: 2024-02-20 01:01:51
品牌 Logo 应用领域
爱特美尔 - ATMEL 微控制器和处理器串行IO控制器通信控制器外围集成电路数据传输时钟
页数 文件大小 规格书
42页 331K
描述
Single Point to Point IEEE 1355 High Speed Controller

T7906EKST/883 技术参数

是否Rohs认证: 不符合生命周期:Active
包装说明:CERAMIC, MQFP-100Reach Compliance Code:not_compliant
HTS代码:8542.31.00.01风险等级:5.81
Is Samacsys:N地址总线宽度:1
边界扫描:YES最大时钟频率:5 MHz
最大数据传输速率:25 MBps外部数据总线宽度:8
JESD-30 代码:S-CQFP-F100JESD-609代码:e0
长度:19.05 mm低功率模式:NO
串行 I/O 数:3端子数量:100
最高工作温度:125 °C最低工作温度:-55 °C
封装主体材料:CERAMIC, METAL-SEALED COFIRED封装代码:QFF
封装等效代码:QFL100,1.3SQ,25封装形状:SQUARE
封装形式:FLATPACK峰值回流温度(摄氏度):NOT SPECIFIED
电源:5 V认证状态:Not Qualified
筛选级别:MIL-STD-883 Class S座面最大高度:2.67 mm
子类别:Other uPs/uCs/Peripheral ICs最大压摆率:80 mA
最大供电电压:5.5 V最小供电电压:4.5 V
标称供电电压:5 V表面贴装:YES
技术:CMOS温度等级:MILITARY
端子面层:TIN LEAD端子形式:FLAT
端子节距:0.635 mm端子位置:QUAD
处于峰值回流温度下的最长时间:NOT SPECIFIED宽度:19.05 mm
uPs/uCs/外围集成电路类型:SERIAL IO/COMMUNICATION CONTROLLER, SERIALBase Number Matches:1

T7906EKST/883 数据手册

 浏览型号T7906EKST/883的Datasheet PDF文件第2页浏览型号T7906EKST/883的Datasheet PDF文件第3页浏览型号T7906EKST/883的Datasheet PDF文件第4页浏览型号T7906EKST/883的Datasheet PDF文件第5页浏览型号T7906EKST/883的Datasheet PDF文件第6页浏览型号T7906EKST/883的Datasheet PDF文件第7页 
Features  
Besides the serial IEEE-1355 link, the T7906E provides several different interface  
types:  
– Host interface  
The host interface provides 8 multiplexed data and address lines to program  
and control the T7906E locally  
– FIFO interface  
The FIFO interface provides the control signals FULL, WRITE, EMPTY and READ  
depending on the direction of the data flow (receive / transmit)  
– ADC interface  
The ADC interface allows to connect an ADC with a width of up to 16 bits directly  
to the T7906E  
– DAC interface  
Single Point to  
Point IEEE 1355  
High Speed  
The DAC interface provides up to 16 bits data lines and the required control  
signals. The data to be sent to the DAC are stored until a command “start DAC”  
is received  
– RAM interface  
The RAM interface provides a 16-bit data bus and a 16-bit address bus. Four  
chip select allow to address 4 different memory partitions. The memory interface  
can be programmed to use up to 7 wait states  
– UART interface  
Controller  
Two independent UART interfaces are included. One UART uses dedicated I/O  
lines whereas the second UART is sharing its pins with the GPIO port  
– General purpose I/O  
T7906E  
This general Purpose Interface provides up to 24 bidirectional signal lines. The  
direction of each GPIO line can be set individually via register  
– Timer / Event Counter  
Two 32-Bit on-chip timers are available. Each timer provides a 32-Bit counter  
and a 32-Bit reload register. The two timers can be operated independently or  
cascaded  
– JTAG (IEEE 1149.1)  
For testing purposes, a standard IEEE 1149.1 interface is provided. It supports  
the JTAG function Bypass, Extest, Sample/preload, All-tristate and IDCode  
Designed on Atmel MG1090E sea of gates matrix and packaged into MQFPF100  
Also called SMCS Lite (or SMCS116)  
Description  
The T7906E provides one IEEE-1355 serial communication link with 0 to 200 Mbit/s  
data transmit rate. It supports both the standard IEEE-1355 link protocol (transparent  
mode) as well as the header generation required for the enhanced transaction layer of  
the TSS901E. This protocol uses specific protocol headers that can be generated by  
the T7906E without requiring an external host controller. These headers are stored in  
specific header registers which allows headers with a length of 0 (equaling the trans-  
parent mode) to eight bytes per packet. Packetization of data sent by the T7906E over  
the link is also done automatically according to the settings of a packet length register.  
Another feature provided by the transaction layer supported by the T7906E is an auto-  
matic checksum generation on the link. This is generated and checked automatically  
by the T7906E without requiring support from a host or other external source. Errors  
on the link are flagged and a special error packet is sent over the link to signal the  
error condition.  
Programming the T7906E internal registers is done via the IEEE-1355 link. All internal  
registers are 8-bit wide addressable. Two simple commands (read and write) suffice  
to access all functions and registers of the T7906E.  
Rev. A – 27-Aug.-01  
1

与T7906EKST/883相关器件

型号 品牌 描述 获取价格 数据表
T7906EKT ATMEL Single Point to Point IEEE 1355 High Speed Controller

获取价格

T7906EKT/883 ATMEL Single Point to Point IEEE 1355 High Speed Controller

获取价格

T7906EKT/SB ATMEL Single Point to Point IEEE 1355 High Speed Controller

获取价格

T7906EKT/SC ATMEL Single Point to Point IEEE 1355 High Speed Controller

获取价格

T7906EKT-E ATMEL Single Point to Point IEEE 1355 High Speed Controller

获取价格

T7906EKTMQ ATMEL Single Point to Point IEEE 1355 High Speed Controller

获取价格