NXP Semiconductors
KV11P64M75
Data Sheet: Technical Data
Rev. 4, 05/2017
Kinetis V Series KV10 and KV11,
MKV11Z128VXX7
MKV11Z64VXX7
MKV10Z64VXX7
MKV10Z128VXX7
MKV11Z128VLX7P
MKV10Z64VLX7P
128/64 KB Flash
75 MHz Cortex-M0+ Based Microcontroller
The Kinetis V Series KV11x MCU family is built on ARM Cortex-
M0+ core and enabled by innovative 90nm thin film storage
(TFS) flash process technology. The KV11x is an extension of
the existing KV10x family providing increased memory, higher
pin count, additional FTMs and a FlexCAN serial interface.
• Dual 16-bit ADCs sampling at up to 1.2 MS/s in 12-bit
mode
32 QFN
64 LQFP
• Highly accurate and flexible motor control timers
• Ideal for industrial motor control applications, inverters, and
low-end power conversion applications
5 x 5 x 1.23 mm Pitch 10 x 10 x 1.4 mm Pitch
0.5 mm
0.5 mm
• Enabled to support Kinetis Motor Suite (KMS), a bundled
hardware and software solution that enables rapid
configuration of BLDC and PMSM motor drive systems
32 LQFP
7 x 7 x 1.4 mm Pitch
0.8 mm
48 LQFP
7 x 7 x 1.4 mm Pitch
0.5 mm
Performance
• Up to 75 MHz ARM Cortex-M0+ based core
Communication interfaces
• One 16-bit SPI module
• One I2C module
Memories and memory interfaces
• Up to 128 KB of program flash memory
• Up to 16 KB of RAM
• Two UART modules
• One FlexCAN module1
Timers
• Programmable delay block
System peripherals
• Nine low-power modes to provide power optimization
based on application requirements
• 8-channel DMA controller
• SWD interface and Micro Trace buffer
• Bit Manipulation Engine (BME)
• External watchdog timer
• Two 6-channel FlexTimers (FTM) for motor control/
general purpose applications
• Four 2-channel FlexTimers (FTM) with quadrature
decoder functionality
• 16-bit low-power timer (LPTMR)
• Advanced independent clocked watchdog
• Memory Mapped Divide and Square Root (MMDVSQ)
module
Operating Characteristics
• Voltage range: 1.71 to 3.6 V
• Flash write voltage range: 1.71 to 3.6 V
• Temperature range (ambient): –40 to 105°C
Clocks
• 32-40 kHz or 4-32 MHz external crystal oscillator
• Multipurpose clock generator (MCG) with frequency-
locked loop referencing either internal or external
reference clock
Analog modules
• Two 16-bit SAR ADCs
• 12-bit DAC
• Two analog comparators (ACMP) containing a 6-bit
DAC and programmable reference input
Security and integrity modules
• 80-bit unique identification (ID) number per chip
• Hardware CRC module
Human-machine interface
• General-purpose I/O
NXP reserves the right to change the production detail specifications as may be
required to permit improvements in the design of its products.