www.make-ps.com
E-mail:info@make-ps.com
800 series
Single, Dual, Triple Output
DC/DC Converter
FEATUREꢀ
• ꢀynchronization
• 6 sided Continuous ꢀhielding
3
• 9.38W/In Power Density
• Efficiency to 82%
• VDE / EN 60950 Approved
• >1,000,000 Hours MTBF
INPUT CHARACTERIꢀTICꢀ
DEꢀCRIPTIONꢀ
Unit/Comments
Min Typ Max
The 800 series is family of miniature, high performance and
high reliability DC/DC converters. The 800 series operates
over 2:1 input voltage ranges of 9 to 18, 18 to 36 or 36 to
72VDC; providing single, dual and triple output combinations
of 5, 12, 15, 5, 12, 15, 5/ 12 and 5/ 15 VDC. ꢀtandard
features include 500VDC input/output isolation, efficiency
as high as 82%, tight line/load regulation and low output
ripple and noise. All 24 models are packaged in compact,
low profile 1” X 2” X 0.4” metal cases.
Input Voltage Range
12 VDC Input Models
24 VDC Input Models
48 VDC Input Models
Remote On / OFF Control
Supply ON
VDC
VDC
VDC
9
12 18
18 24 36
36 48 72
0 VDC to 0.6 VDC
1 VDCto 5VDC
Supply OFF
Logic Referenced to Negative Input
Input Filter
LC Type
See Model Selection
Guide
Input Fuse Rating
OUTPUT CHARACTERIꢀTICꢀ
Min Typ Max Unit/Comments
Output Voltage Accuracy
1
Single & Dual Outputs
Triple Outputs- Primary
1.0 %
1.0 %
6.0 %
1
1
- Auxiliaries
Voltage Balance:
Dual Outputs
Triple Outputs (Auxiliaries)
Minimum Load
1.0 %; Equal Output Loads
1.0 %; Equal Output Loads
Full Load
10%
GENERAL CHARACTERIꢀTICꢀ
Line Regulation
Single & Dual Outputs
Triple Outputs- Primary
- Auxiliaries
Load Regulation
Single Outputs
Dual Outputs
Triple Outputs- Primary
- Auxiliaries
Ripple/Noise
2
0.5 %
2
Min Typ Max Unit/Comments
0.5 %
2
Switching Frequency
Isolation Voltage
100
500
1000
1
kHz
5.0
%
VDC, 1 minute
Mohm, 500VDC
Million Hours,
3
3
Isolation Resistance
MTBF (MIL-HBK-217F)
0.5 %
1.0 % ; Equal Loads
o
3
+25 C, Ground
Benign
0.5 %
3
6.0 % ; Equal Loads
2
% of Vout
(20 MHz B.W.)
Continuous, Auto-
matic Recovery
Short Circuit Protection
Transient Recovery Time
200 μS to within1% error
band for 50% step
load change
1
= Output voltage at nominal line & FL
= % Output voltage measured from min. input line to maximum
= Output voltage measured from FL to 10% Load
o
Temperature Coefficient
Over Voltage Protection
0.01 % per C
2
3
See Model Selection Guide
>> B-85