14-Port, 32-Lane, 160Gbps,
Gen2 RapidIO Switch
CPS-1432
Datasheet
Description
Features
•
RapidIO ports
The CPS-1432 (80HCPS1432) is a RapidIO Specification (Rev. 2.1)
compliant Central Packet Switch whose functionality is central to
routing packets for distribution among DSPs, processors, FPGAs,
other switches, or any other RapidIO-based devices. It can also be
used in RapidIO backplane switching. The CPS-1432 supports Serial
RapidIO (S-RIO) packet switching (unicast, multicast, and an optional
broadcast) from any of its 14input ports to any of its 14 output ports.
— 32 bidirectional S-RIO lanes
— Port widths of 1x, 2x, and 4x allow up to 20 Gbps per port
— Port speeds selectable: 6.25, 5, 3.125, 2.5, or 1.25 Gbaud
— Support Level I defined short or long haul reach, and Level II
defined short-, medium-, or long-run reach for each PHY speed
— Error Management Extensions support
— Software-assisted error recovery, supporting hot swap
Block Diagram
2
•
•
I C Interfaces
2
— Provides I C port for maintenance and error reporting
Quadrant 0
Lanes 0-3, 16-19
Quadrant 3
Lanes 12-15, 28-31
— Master or Slave operation
— Master allows power-on configuration from external ROM
Ports 0, 4, 12
Ports 3, 7, 11, 15
— Master mode configuration with external image compressing and
checksum
Switch
CPS-1432
RapidIO Gen2
Switch Fabric
— 160 Gbps peak throughput
— Non-blocking data flow architecture
— Configurable for Cut-Through or Store-and-Forward data flow
— Very low latency for all packet lengths and load conditions
— Internal queuing buffer and retransmit buffer
— Standard transmitter- or receiver-controlled flow control
— Global routing or Local Port routing capability
— Supports up to 40 simultaneous multicast masks, with broadcast
Event Management and Maintenance
Registers
I2C Controller
Ports 1, 5, 13
Lanes 4-7, 20-23
Quadrant 1
JTAG Controller
Ports 2, 6, 10, 14
Lanes 8-11, 24-27
Quadrant 2
— Performance monitoring counters for performance and
diagnostics analysis. Per input port and output port counters
•
•
SerDes
— Transmitter pre-emphasis and drive strength + receiver
equalization provides best possible signal integrity
Typical Applications
— Embedded PRBS generation and detection with programmable
polynomials support Bit Error Rate testing
•
•
•
•
High-performance computing
Wireless
Additional Information
Defense and aerospace
Video and imaging
— Packet Trace/Mirror. Each input port can copy all incoming
packets matching user-defined criteria to a “trace” output port.
— Packet Filter. Each input port can filter (drop) all incoming packets
matching user-defined criteria.
2
— Device configurable through any of S-RIO ports, I C, or JTAG
— Full JTAG Boundary Scan Support (IEEE1149.1 and 1149.6)
— Lidless 784-FCBGA Package: 25 X 25 mm,1.0 mm ball pitch
©2017 Integrated Device Technology, Inc.
1
June 26, 2017