TVS Diodes
Axial Leaded – 5000W > 5KP-HR series
Pb e3
RoHS
5KP-HR Series
Description
Uni-directional
The 5KP-HR High Reliability Series is designed specifically
to protect sensitive electronic equipment from voltage
transients induced by lightning and other transient voltage
events.
Features
Bi-directional
• 5000W peak pulse
capability at 10/1000μs
waveform, repetition rate
(duty cycles):0.01%
• Glass passivated chip
junction in P600 package
• Very fast response time
• Excellent clamping
capability
•Typical failure mode is
short from over-specified
voltage or current
• Whisker test is conducted
based on JEDEC
JESD201A per its table 4a
and 4c
• IEC-61000-4-2 ESD
• High temperature
soldering guaranteed:
260C/10 seconds / 0.375”,
(9.5mm) lead length, 5
lbs., (2.3kg) tension
• VBR @TJ= VBR@25°C
x (1+αT x (TJ - 25))
(αT:Temperature
Coefficient, typical value
is 0.1%)
• Plastic package is
flammability rated V-0 per
Underwriters Laboratories
• Lead-free matte tin plated
package
• Halogen free and RoHS
compliant
Agency Approvals
AGENCY
AGENCY FILE NUMBER
E230531
Maximum Ratings andThermal Characteristics
(TA=25OC unless otherwise noted)
Parameter
Symbol
PPPM
Value
5000
Unit
W
Peak Pulse Power Dissipation by
10/1000μsTest Waveform (Fig.2)
(Note 1)
• Pb-free E3 means 2nd
level interconnect is Pb-
free and the terminal finish
material is tin(Sn) (IPC/
JEDEC J-STD-609A.01)
30kV(Air), 30kV (Contact)
Steady State Power Dissipation on
Infinite Heat Sink atTL=75ºC
PD
8.0
W
A
• ESD protection of data
lines in accordance with
IEC 61000-4-2
• EFT protection of data
lines in accordance with
IEC 61000-4-4
Peak Forward Surge Current, 8.3ms
Single Half Sine Wave Unidirectional
Only (Note 2)
Maximum Instantaneous Forward
Voltage at 100A for Unidirectional
Only (Note 3)
IFSM
400
VF
3.5/5.0
V
• Low incremental surge
resistance
Operating Junction and Storage
Temperature Range
TJ, TSTG -55 to 175
°C
• Typical IR less than 2μA
when VBR min>12V
TypicalThermal Resistance Junction
to Lead
RuJL
RuJA
8.0
40
°C/W
°C/W
TypicalThermal Resistance Junction
to Ambient
Applications
Notes:
1. Non-repetitive current pulse , per Fig. 4 and derated aboveTJ (initial) =25OC per Fig. 3.
TVS devices are ideal for the protection of I/O interfaces,
VCC bus and other vulnerable circuits used in telecom,
computer, industrial and consumer electronic applications.
2. Measured on 8.3ms single half sine wave or equivalent square wave, duty cycle=4 per
minute maximum.
3. VF < 3.5V for single die parts and VF< 5.0V for stacked-die parts.
Functional Diagram
Bi-directional
Cathode
Anode
Uni-directional
© 2016 Littelfuse, Inc.
Specifications are subject to change without notice.
Revised: 09/10/16