3mm Square
® OptopipeTM
Optical Light Pipe, Quad High
515-1023-803
3.20
[.126]
.76
[.030]
REF.
Recommended
LIGHTSHIELDS
2 PLCS
MicroLED SMT LEDs
for use with 515-1023-803
4.95
[.195]
3.18
[.125]
4.95
[.195]
21.59
[.850]
2
4.95
[.195]
5.16
3.53
PART NO.
597-3001-1xx
597-3111-1xx
597-3211-1xx
597-3301-1xx
597-3401-1xx
597-7701-1xx
597-7721-1xx
597-7731-1xx
COLOR
Red
PAGE #
1-19
4.45
[.203]
[.139]
[.175]
4.31
[.170]
4.45
NOTE:
[.175] C.L. of LED
4.45
[.175]
AlGaAs Red
Orange
1-19
6.02
[.237]
19.69
5.31
[.209]
[.775]
[.116 DIA] TYP.
(2) PLACES
1-19
28.75
[1.132]
8.23
[.324]
Green
1-19
13.34
[.525]
9.07
[.357]
4.45
[.175]
Yellow
1-19
Direction
of Light
Red/Green
Yellow/Green
Red/Yellow
1-20
1.24
[.049]
.99
[.039]
1-20
2.01
[.079]
NOTE: designed for
post-reflow
PC board insertion.
1-20
.51
[.020]
.99
[.039]
4.12
[.162]
Ø [.113 ± .002]
RECOMMENDED PIN HOLES AND SOLDER PAD
LAYOUT FOR SUGGESTED MicroLED LEDs
Dimensions in mm [inches]
COMPONENT SIDE OF PRINTED CIRCUIT BOARD
LED Data
Features
For absolute maximum ratings and other
electrical and optical data on the recommended
LEDs, refer to LED data sheets.
• High transmissivity polycarbonate material
• UL94V-0 compliance
• ESD protection (circuit isolation from front panel)
• Wide viewing angle
Operating/Storage Temperature
• Arrays reduce insertion costs
• Allows quad level SMT indicators
• Secures to PCB by press-fit
–30°C to +100°C
Dialight Optopipe Light Pipe Description
This Optopipe™ has a relatively low vertical height considering the number of light pipe elements. The element’s
square emitting surfaces are vertically spaced 0.203" from the PCB to the first element, and then 0.195" between each of
the other elements. This Optopipe™ is held in place by 2 press-fit pins on the bottom of the device. The wide base offers
added stability to the installed part. The light pipe is not attached to the panel at any point, but protrudes through holes in
the panel. This Optopipe™ was specifically designed to accept Dialight’s 597 Series Type 1210 LEDs. The light pipe
material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index.
Dialight can provide custom Optopipe™ solutions for your applications.
Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com
2-51