Radiation Hardened 8-Channel Source Driver
IS-2981RH, IS-2981EH
Features
• Electrically screened to SMD # 5962-00520
The Star*Power Radiation Hardened
IS-2981RH, IS-2981EH are monolithic
devices designed for use in high-side
switching applications that benefit
from separate grounds for the logic
• QML qualified per MIL-PRF-38535 requirements
TM
• Radiation environment
- Single event latch-up immune DI process
- High dose rate . . . . . . . . . . . . . . . . . . . . . . . . . . 100krad(Si)
and loads. The devices have a 5V to 80V operating supply
voltage range and is capable of sourcing -200mA continuously
from each output. The outputs are controlled by active-high
inputs and may be paralleled to increase the drive current. The
output clamp diodes prevent device damage, when switching
inductive loads.
- Low dose rate . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50krad(Si)
• Input voltage range . . . . . . . . . . . . . . . 0.0V to V (20V max)
CC
• Supply voltage range . . . . . . . . . . . . . . . . . . . . . . . . . 5V to 80V
• Turn-on delay time . . . . . . . . . . . . . . . . . . . . . . . . . . . 2µs (max)
• Turn-off delay time. . . . . . . . . . . . . . . . . . . . . . . . . . 11µs (max)
Constructed with the Intersil bonded wafer, dielectrically
isolated HVTDLM process, these single event latch-up immune
devices have been specifically designed to provide highly
reliable performance in harsh radiation environments. They
are fully guaranteed for 100krad(Si) high dose rate and
50krad(Si) low dose rate total dose performance through
wafer-by-wafer radiation testing, and are production tested
over the full military temperature range.
• Output clamp diode, V . . . . . . . . . . . . . . . . . . . . .-1.75V (max)
F
Applications
• Drivers for various loads
- Relays, solenoids and motors
• Reliable replacement of discrete solutions
Specifications for Rad Hard QML devices are controlled by the
Defense Logistics Agency Land and Maritime (DLA). The SMD
numbers listed below must be used when ordering.
• Interfacing between low-level logic and high-current loads
Detailed Electrical Specifications for these devices are
contained in SMD 5962-00520. A “hot-link” is provided on our
homepage for downloading
Pin Configuration
IS1-2981RH-Q, IS1-2981EH-Q
(CDIP2-T18)
TOP VIEW
1
2
3
4
5
6
7
8
9
18
17
IN 1
IN 2
IN 3
IN 4
IN 5
IN 6
IN 7
IN 8
OUT 1
OUT 2
16 OUT 3
15 OUT 4
14 OUT 5
13 OUT 6
12
11
10
OUT 7
OUT 8
GND
V
CC
June 24, 2013
FN4869.1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1
1-888-INTERSIL or 1-888-468-3774 | Copyright Intersil Americas LLC 2000, 2013. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.