0
QPRO Series Configuration
PROMs (XQ) including
R
Radiation-Hardened Series (XQR)
0
2
DS062 (v3.0) February 8, 2000
Preliminary Product Specification
Features
Description
•
•
•
XQ1701L/XQR1701L
The QPRO™ series XQ1701L are Xilinx 3.3V high-density
configuration PROMs. The XQR1701L are radiation hard-
ened. These devices are manufactured on Xilinx QML certi-
fied manufacturing lines utilizing epitaxial substrates and
TID lot qualification (per method 1019).
QML Certified
Configuration one-time programmable (OTP) read-only
memory designed to store configuration bitstreams of
Xilinx FPGA devices
When the FPGA is in Master Serial mode, it generates a
configuration clock that drives the PROM. A short access
time after the rising clock edge, data appears on the PROM
•
Simple interface to the FPGA; requires only one user
I/O pin
•
•
Cascadable for storing longer or multiple bitstreams
DATA output pin that is connected to the FPGA D pin. The
IN
Programmable reset polarity (active High or active
Low) for compatibility with different FPGA solutions
FPGA generates the appropriate number of clock pulses to
complete the configuration. Once configured, it disables the
PROM. When the FPGA is in Slave Serial mode, the PROM
and the FPGA must both be clocked by an incoming signal.
Figure 1 shows a simplied block diagram.
•
Supports XQ4000XL/Virtex fast configuration mode
(15.0 MHz)
•
•
•
Available in 44-pin ceramic LCC (M grade) package
Available in 20-pin SOIC package (XQ1701L only)
Multiple devices can be concatenated by using the CEO
output to drive the CE input of the following device. The
clock inputs and the DATA outputs of all PROMs in this
chain are interconnected. All devices are compatible and
can be cascaded with other members of the family.
Programming support by leading programmer
manufacturers.
•
Design support using the Xilinx Alliance and
Foundation series software packages.
For device programming, either the Xilinx Alliance or Foun-
dation series development system compiles the FPGA
design file into a standard Hex format, which is then trans-
ferred to most commercial PROM programmers.
•
XQR1701L (only)
•
Fabricated on Epitaxial Silicon to improve latch
performance (parts are immune to Single Event
Latch-up)
•
•
•
Single Event Bit Upset immune
Total Dose tolerance in excess of 50K rads(Si)
All lots subjected to TID Lot Qualification in accordance
with method 1019 (dose rate ~9.0 rads(Si)/sec)
•
XQ1701L (only)
•
Also available under the following Standard Microcircuit
Drawing (SMD): 5962-9951401. For more information
contact hte Defense Supply Center Columbus (DSCC):
http://www.dscc.dla.mil/Programs/Smcr/
©2001 Xilinx, Inc. All rightsreserved. All Xilinxtrademarks, registered trademarks, patents, and disclaimers are as listed at http://www.xilinx.com/legal.htm
All other trademarks and registered trademarks are the property of their respective owners. All specifications are subject to change without notice.
.
DS062 (v3.0) February 8, 2000
www.xilinx.com
1
Preliminary Product Specification
1-800-255-7778