54LVTH16373
3.3V ABT16-Bit Transparent
D-Type Latches
1OE
1Q1
1Q2
GND
1Q3
1Q4
VCC
1Q5
1Q6
GND
1Q7
1Q8
2Q1
2Q2
GND
2Q3
2Q4
1
48
1LE
1D1
1D2
GND
1D3
1D4
VCC
1D5
1D6
GND
1D7
1D8
2D1
2D2
GND
2D3
2D4
VCC
2D5
2D6
GND
2D7
2D8
2LE
Logic Diagram (PositiveLogic)
1/24
1OE/2OE
1LE/2LE
48/25
C1
1D
2/13
1Q1/2Q1
54LVTH16373
47/36
1D1/2D1
VCC
2Q5
2Q6
GND
2Q7
2Q8
To Seven Other Channels
Logic Diagram
2OE
24
25
FEATURES:
DESCRIPTION:
•
•
•
3.3V low voltage advanced BiCMOS technology (LVT) 16-
Maxwell Technologies’ 54LVTH16373 16-bit transparent D-
type latches with 3-state output features a greater than 100
krad (Si) total dose tolerance, dependent upon space mission.
The 54LVTH16373 is designed for low voltage (3.3V) VCC
operation, but with the capability to provide a TTL interface to
a 5V system environment. It is suitable for implementing buffer
registers, I/O ports, bidirectional bus drivers, and working reg-
isters. The 54LVTH16373 can be used as two 8-bit latches or
one 16-bit latch. When the latch-enable (LE) input is low, the
Q output are latched at the levels set up at the data (D) inputs.
When LE is high, the Q outputs follow the D inputs. A buffered
output-enable (OE) input can be used to place the eight out-
puts in either a normal logic state or a high impedance state.
In the high impedance state, the outputs neither load nor drive
the bus lines significantly. The high impedance state and the
increased drive provide the capability to drive bus lines with-
out the need for interface or pullup components. OE does not
affect internal operations of the latch. Old data can be retained
or new data can be entered while the outputs are in the high
impedance state.
bit transparent D-type latches with 3-state outputs
Total dose hardness:
- > 100 krad (Si), dependent upon space mission
Single event effect:
- SELTH : No LU > 119 MeV/mg/cm2
Package: 48 pin RAD-PAK® flat package
Operating temperature range:
- 55 to 125°C
•
•
•
•
Distributed VCC and GND pin configuration minimizes high-
speed switching noise
Supports mixed-mode signal operation
- 5V input and output voltages with 3.3V VCC
Supports unregulated battery operation down to 2.7V
Typical VOLP (output ground bounce) < 0.8V at VCC=3.3V,
TA=25°C
•
•
•
Latch-up performance exceeds 500mA per JEDEC stan-
dard
•
•
Supports live insertion
Bus-hold data inputs eliminate the need for external pullup
resistors
Maxwell Technologies' patented RAD-PAK® packaging technol-
ogy incorporates radiation shielding in the microcircuit pack-
age. It eliminates the need for box shielding while providing
the required radiation shielding for a lifetime in orbit or space
mission. In a GEO orbit, RAD-PAK provides greater than 100
krad (Si) radiation dose tolerance. This product is available
with screening up to Class S.
1000603
12.19.01 Rev 1
1
All data sheets are subject to change without notice
(858) 503-3300 - Fax: (858) 503-3301 - www.maxwell.com
©2001 Maxwell Technologies
All rights reserved.