SMD POWER RESISTORS – AEC-Q200 QUALIFIED
Type 3522 Series
Key Features
3 Watts at
70°C
Small size to
power ratio
Supplied on
tape
Value marked
on resistor
Available via
distribution
500 volt
maximum
TE Connectivity is pleased to announce that our 3522 series resistor is now AEC-
overload
Q200 qualified. This low cost high power device, suitable for auto placement in
volume and for most applications, including high frequency operations, owing to
the short lead structure is supplied as standard on 7 inch Reels of 2000 pieces
per reel.
250 volt
working
voltage
Terminal finish
matte Sn over
Ni
Characteristics – Electrical
Power rating at 70°C
3W
AEC-Q200
Qualified
Rated current (Jumper)
Max. overload current (Jumper)
Max working voltage
2.5A
10A
250V
500V
Max overload voltage
Dielectric withstand voltage
Temperature range
500V
-55°C ~ +155°C
70°C
Ambient temperature
* Rated continuous working voltage (RCWV) shall be determined from
RCWV = √(Rated Power x Resistance Value), or Maximum RCWV listed above,
whichever is less
**Recommended Circuit Board Design - If this device is anticipated to run at full
continuous power then action to improve the cooling should be taken. This can
be a metal substrate, copper pad left under the chip, an opening in the PCB or
enlarged silver conductor pads each end.
Dimensions in
Dimensions Shown for
reference purposes only.
Specifications subject to
change
9-1773463-7 Rev. G 04/2020
For Email, phone or live chat,
go to: www.te.com/help
millimetres unless
otherwise specified