SILICON DESIGNS, INC
Model 2210
ANALOG ACCELEROMETER MODULE
! Capacitive Micromachined
! Nitrogen Damped
! 4V Differential Output or
0.5V to 4.5V Single Ended Output
! Fully Calibrated
! Low Power Consumption
! -40 to +85EC Operation
! +9 to +32V DC Power
! Simple Four Wire Connection
ACTUAL SIZE
! Low Impedance Outputs Will Drive
Up To 15 Meters of Cable
! Responds to DC and AC Acceleration
ORDERING INFORMATION
Full Scale
Model
! Non Standard g Ranges Available
! Rugged Anodized Aluminum Module
! Low Cost
Acceleration
Number
±
±
2 g
5 g
2210-002
2210-005
2210-010
2210-025
2210-050
2210-100
2210-200
2210-400
± 10 g
± 25 g
± 50 g
±100 g
±200 g
±400 g
! Serialized for Traceability
DESCRIPTION
The Model 2210 accelerometer module combines an integrated model 1210L accelerometer with high drive, low
impedance buffering for measuring acceleration in commercial/industrial environments. It is tailored for zero to
medium frequencyinstrumentation applications. Theanodized aluminum case is epoxysealed and is easilymounted
via two #4 (or M3) screws. On-board regulation is provided to minimize the effects of supply voltage variation. It is
relatively insensitive to temperature changes and thermal gradients. The cable’s shield is electrically connected to
the case while the ground (GND) wire is isolated from the case. An optional initial calibration sheet (2210-CAL) and
periodic calibration checking are also available.
OPERATION
The Model 2210 accelerometer module produces two analog voltage outputs which vary with acceleration as shown
in the graph on the next page. The sensitive axis is perpendicular to the bottom of the package, with positive
acceleration defined as a force pushing on the bottom of the package. The signal outputs are fully differential about
a common mode voltage of approximately 2.5 volts. The output scale factor is independent from the supply voltage
of +9 to +32 volts. At zero acceleration the output differential voltage is nominally 0 volts DC; at full scale
acceleration the output differential voltage is 4 volts DC respectively.
APPLICATIONS
! VIBRATION MONITORING
! VIBRATION ANALYSIS
! MACHINE CONTROL
! MODAL ANALYSIS
! ROBOTICS
! CRASH TESTING
! INSTRUMENTATION
Silicon Designs, Inc. ! 1445-NW Mall Street, Issaquah, WA 98027-5344 ! Phone: 425-391-8329 ! Fax: 425-391-0446
web site: www.silicondesigns.com [page 1] May 07