Protection Relays
Pump Controls and Liquid Level Controls
201-100-SLD
*
Single-Channel Seal-Leak Detector
UL listed when used in combination
with OT08PC socket only.
Description
The model 201-100-SLD is an 8-pin plug-in style seal-leak
detector to sense seal failures on submersible pumps. A
microcontroller-based relay that monitors the shaft seal of
a submersible pump motor. A resistive probe is installed in
the seal cavity. If water leaks into the pump, the resistance
measured by the probe decreases. When the resistance drops
below the sensitivity setpoint, the unit will trip and the relay
contacts will change state. The unit will automatically reset
when a fault is cleared.
Features & Benefits
ꢀJ
LED status indicator
ꢀJ
Compact plug-in design
ꢀJ
DIN rail or surface mountable via octal base
Accessories
OT08PC 8-pin Octal Socket
Octal Socket for plug-in units. 8-pin surface &
DIN rail mountable. Rated for 10A @ 600VAC.
Specifications
Control Voltage
Frequency
Wiring Diagram
110/120VAC nominal
50/60Hz
Sensitivity
4.7k-100kΩ
Probe Sense Voltage
Output contact Rating
Pilot Duty
General Purpose
Operating Temperature
Storage
5vdc pulsed
SPDT
480VA @240VAC
10A @240VAC
-40° to 70°C (-40° to 158°F)
-40° to 80°C (-40° to 176°F)
5 W
Maximum Input Power
Relative Humidity
10-95%, non-condensing per IEC 68-2-3
Electrostatic Discharge (ESD) IEC 61000-4-2, Level 3, 6kV contact, 8kV air
Radio Frequency Immunity,
Radiated
150MHz, 10V/m
Fast Transient Burst
IEC 61000-4-4, Level 3, 3.5kV input power
and controls
IEC
IEC 61000-4-5, Level 3, 4kV line-to-line;
level 4, 4kV line-to-ground
C62.41 Surge and Ring Wave Compliance
to a level of 6kV line-to-line
Meets UL508 (2 x rated V + 1000V for 1 min.)
UL508 (File #E68520)
ANSI/IEEE
Hi-Potential Test
UL*
CE
IEC 60947-6-2
Enclosure
Dimensions
Polycarbonate
H 44.45 mm (1.75”); W 60.325 mm (2.375”);
D (with socket) 104.78 mm (4.125”)
0.7 lb. (11.2 oz., 317.51 g)
Weight
Mounting Method
DIN rail or surface mount (plug into
OT08PC socket)
Socket Available
Approvals
Model OT08PC (UL Rating 600V)
UL, CE
Note: Manufacturer’s recommended screw terminal torque for the RB Series and OT Series
Octal Sockets is 12 in.-lbs.
*Must use Model OT08PC socket for UL Rating!
The 600V socket can be surface mounted or installed on DIN Rail.
© 2016 Littelfuse Protection Relays & Controls
www.littelfuse.com/201100sld
Rev: 1-A-062816