1894-40KLFT

更新时间： 2024-11-05 06:23:35

品牌	Logo	应用领域
艾迪悌 - IDT		网络接口电信集成电路电信电路
页数	文件大小	规格书
52页	460K
描述
10BASE-T/100BASE-TX INTEGRATED PHYCEIVER WITH RMII INTERFACE

阅读下载

中文翻译

获取价格

技术参数
数据手册

如果您发现信息不准确，欢迎纠错

1894-40KLFT 技术参数

是否无铅：	不含铅	是否Rohs认证：	符合
生命周期：	Active	零件包装代码：	QFN
包装说明：	6 X 6 MM, ROHS COMPLIANT, QFN-40	针数：	40
Reach Compliance Code：	compliant	HTS代码：	8542.39.00.01
风险等级：	5.73	Is Samacsys：	N
数据速率：	100000 Mbps	JESD-30 代码：	S-XQCC-N40
JESD-609代码：	e3	长度：	6 mm
湿度敏感等级：	3	功能数量：	1
端子数量：	40	收发器数量：	1
最高工作温度：	70 °C	最低工作温度：
封装主体材料：	UNSPECIFIED	封装代码：	HVQCCN
封装等效代码：	LCC40,.24SQ,20	封装形状：	SQUARE
封装形式：	CHIP CARRIER, HEAT SINK/SLUG, VERY THIN PROFILE	峰值回流温度（摄氏度）：	260
电源：	3.3 V	认证状态：	Not Qualified
座面最大高度：	1 mm	子类别：	Network Interfaces
最大压摆率：	0.16 mA	标称供电电压：	3.3 V
表面贴装：	YES	技术：	CMOS
电信集成电路类型：	INTERFACE CIRCUIT	温度等级：	COMMERCIAL
端子面层：	Matte Tin (Sn) - annealed	端子形式：	NO LEAD
端子节距：	0.5 mm	端子位置：	QUAD
处于峰值回流温度下的最长时间：	30	宽度：	6 mm
Base Number Matches：	1

1894-40KLFT 数据手册

DATASHEET

10BASE-T/100BASE-TX INTEGRATED PHYCEIVER WITH RMII INTERFACE

ICS1894-40

Description

Features

The ICS1894-40 is a low-power, physical-layer device

(PHY) that supports the ISO/IEC 10Base-T and

100Base-TX Carrier-Sense Multiple Access/Collision

Detection (CSMA/CD) Ethernet standards, ISO/IEC

8802-3.

• Supports category 5 cables with attenuation in excess of

24dB at 100 MHz.

• Single-chip, fully integrated PHY provides PCS, PMA,

PMD, and AUTONEG sub layers functions of IEEE

standard.

The ICS1894-40 is intended for MII, Node applications that

require the Auto-MDIX feature that automatically corrects

crossover errors in plant wiring.

• 10Base-T and 100Base-TX IEEE 8802.3 compliant

• MIIM (MDC/MDIO) management bus for PHY register

configuration

The ICS1894-40 incorporates Digital-Signal Processing

(DSP) control in its Physical-Medium Dependent (PMD)

sub layer. As a result, it can transmit and receive data on

unshielded twisted-pair (UTP) category 5 cables with

attenuation in excess of 24 dB at 100MHz. With this

IDT-patented technology, the ICS1894-40 can virtually

eliminate errors from killer packets.

• RMII interface support with external 50 MHz system clock

• Single 3.3V power supply

• Highly configurable, supports:

– Media Independent Interface (MII)

– Auto-Negotiation with Parallel detection

– Node applications, managed or unmanaged

– 10M or 100M full and half-duplex modes

– Loopback mode for Diagnostic Functions

Auto-MDI/MDIX crossover correction

• Low-power CMOS (typically 300 mW)

• Power-Down mode typically 21mW

• Clock and crystal supported

The ICS1894-40 provides a Serial-Management Interface

for exchanging command and status information with a

Station-Management (STA) entity. The ICS1894-40

Media-Dependent Interface (MDI) can be configured to

provide either half- or full-duplex operation at data rates of

10 Mb/s or 100Mb/s.

In addition, the ICS1894-40 includes a programmable

interupt output function. This function consists of a digital

output pin, an interrupt control register, a set of interrupt

status register bits and a corresponding set of interrupt

enable bits, and a pre-defined set of events which can be

assigned as one of the interrupt sources. The purpose of

this function is to notify the host of this PHY device when

certain event happens via interrupt (the logic level on

interrupt output pin going low or going high) instead of

polling by the host. The events that could be used to

generate interrupts are: receiver error, Jabber, page

received, parallel detect fault, link partner acknowledge, link

status change, auto-negotiation complete, remote fault,

collision, etc

• Interrupt pin option

• Fully integrated, DSP-based PMD includes:

– Adaptive equalization and baseline-wander

correction

– Transmit wave shaping and stream cipher

scrambler

– MLT-3 encoder and NRZ/NRZI encoder

• Single power supply (3.3 V)

• Built-in 1.8 V regulator for core

• Available in 40-pin (5mm x 5mm) QFN package, Pb-free

• Available in Industrial Temp and Lead Free

Applications: NIC cards, PC motherboards, switches,

routers, DSL and cable modems, game machines, printers,

network connected appliances, and industrial equipment.

IDT™ / ICS™ 10BASE-T/100BASE-TX INTEGRATED PHYCEIVER WITH RMII INTERFACE 1

ICS1894-40

REV C 092909

12 3 4 5 6 7...52

中文翻译

下载PDF

与1894-40KLFT相关器件

型号	品牌	获取价格	描述	数据表
1894419	PHOENIX	获取价格	Strip Terminal Block, 12A, 1 Row(s), 1 Deck(s)
189444-1	MACOM	获取价格	COPALUM Terminals and Splices (For Solid & Stranded Aluminum or Copper Wire)
1894448	PHOENIX	获取价格	GMSTB 2,5/ 4-ST-7,62 BK
189447-1	MACOM	获取价格	COPALUM Terminals and Splices (For Solid & Stranded Aluminum or Copper Wire)
1894574	PHOENIX	获取价格	Barrier Strip Terminal Block,
1894600	PHOENIX	获取价格	Barrier Strip Terminal Block,
1894613	PHOENIX	获取价格	Barrier Strip Terminal Block, 12A, 2.5mm2, 1 Row(s), 1 Deck(s)
1894655	PHOENIX	获取价格	Barrier Strip Terminal Block
1894723	PHOENIX	获取价格	Barrier Strip Terminal Block,
1894794	PHOENIX	获取价格	Barrier Strip Terminal Block,

与1894-40KLFT相关文章

英伟达新AI芯片Rubin或提前半年亮相
2024-11-05

13
苹果iPhone 17将全系采用三星/LG显示LTPO OLED面板
2024-11-05

9
三星深化印度制造布局，供应链本地化进程加速
2024-10-29

35
芯擎科技“星辰一号”自动驾驶芯片点亮成功，2025年量产在即
2024-10-29

31

产品中心

服务支持

精选活动

关于我们

帮助中心

1894-40KLFT

1894-40KLFT 技术参数

1894-40KLFT 数据手册

与1894-40KLFT相关器件

与1894-40KLFT相关文章

您还可以找

产品中心

服务支持

精选活动

关于我们

帮助中心

1894-40KLFT

1894-40KLFT 技术参数

1894-40KLFT 数据手册

与1894-40KLFT相关器件

与1894-40KLFT相关文章

您还可以找

您在本页遇到什么问题？