1500 series
Single, Dual, Triple Output
DC/DC Converter
www.marteꢁpower.com
FEꢀTURES
• Synchronization
• 13.3W/In Power Density
3
• Efficiency to 87%
• UL 1950 ꢀpproved
• VDE / EN 60950 ꢀpproved
• >700,000 Hours MTBF
• 6 sided Continuous Shielding
• Output Voltage Trimming
INPUT CHꢀRꢀCTERISTICS
DESCRIPTIONS
Unit/Comments
Min Typ Max
The 1500 series 15 watts high performance DC/DC
converters are cost effective solution to the high reliability
and performance requirements of power distribution
systems in applications ranging from high speed data
communications equipment to industrial robotic systems.
The 1500 series operates over 2:1 input voltage ranges of
9 to 18, 18 to 36 or 36 to 72VDC; providing single, dual and
triple output combinations of 5, 12, 15, 5, 12, 15, 5/ 12 and
5/ 15 VDC. ꢀll models are pacꢁaged in compact, low profile
2” X 2” X 0.4” metal cases.
Input Voltage Range
12 VDC Input Models
24 VDC Input Models
48 VDC Input Models
Remote On / OFF Control
Supply ON
VDC
VDC
VDC
9
12 18
18 24 36
36 48 72
5.5 VDC or Open Circuit
0 VDCto 0.8VDC
Supply OFF
Logic Referenced to Negative Input
Reverse Polarity Input Current
Input Filter
Amp
12
Internal Capacitor;
External 10-20 μF
cap recommended
across input pins
See Model Selection
Guide
OUTPUT CHꢀRꢀCTERISTICS
Min Typ Max Unit/Comments
Input Fuse Rating
Output Voltage Accuracy
1
Single & Dual Outputs
Triple Outputs- Primary
- Auxiliaries
1.0 %
1.0 %
5.0 %
5.0 %
1
1
1
Output Voltage Adjustment
Voltage Balance:
Dual Outputs
Triple Outputs (Auxiliaries)
Minimum Load
Line Regulation
Single & Dual Outputs
Triple Outputs - Primary
- Auxiliaries
1.0 %; Equal Output Loads
1.0 %; Equal Output Loads
10% Full Load
GENERꢀL CHꢀRꢀCTERISTICS
2
Min Typ Max Unit/Comments
0.5 %
2
Switching Frequency
Isolation Voltage
Isolation Resistance
Isolation Capacitance
MTBF (MIL-HBK-217F)
100
1000
1000
kHz
0.5 %
2
VDC, 1 minute
Mohm, 500VDC
pF, 100kHz, 1Volt
Thousand Hours,
5.0
%
Load Regulation
Single Outputs
3
3
60
0.3 %
700
Dual Outputs
1.0 % ; Equal Loads
o
3
+25 C, Ground
Triple Outputs- Primary
- Auxiliaries
Ripple/Noise
5V Outputs
0.5 %
3
Benign
5.0 % ; Equal Loads
75 mV p-p, Nom.Line FL,
20Mhz B.W. using
1 μf bypass capacitor
% of Vout
Continuous, Auto-
matic Recovery
12V and 15V Outputs
Short Circuit Protection
1
Transient Recovery Time
200 μS to within1% error
band for 50% step
load change
0.01 % per C
See Model Selection Guide
1
= Output voltage at nominal line & FL
o
2
3
Temperature Coefficient
Over Voltage Protection
= % Output voltage measured from min. input line to maximum
= Output voltage measured from FL to 10% Load
Martek Power reserves the right to change specifications without notice.
B-107