Instruction Sheet
CERTI-CRIMP* II Tool Holder Assembly
1213860-1 (for Use with the SDE Electric
Bench Terminator)
408-10021
16 MAR 10 Rev C
Crimping Head
CERTI -CRIMP II Tool
Holder Assembly
1213860-1 (for use
with the SDE Electric
Bench Terminator)
SDE Electric
Bench Terminator
Figure 1
For information concerning the setup and operation of
the SDE Electric Bench Terminator, refer to customer
manual 409--10052.
1. INTRODUCTION
The CERTI--CRIMP II Tool Holder Assembly
1213860--1 is used to adapt the crimping head from a
CERTI--CRIMP II Hand Tool to an SDE Electric
Bench Terminator. Figure 1 shows a typical crimping
head, mounted to CERTI--CRIMP II Tool Holder
Assembly 1213860--1, installed onto an SDE Electric
Bench Terminator.
Read this instruction sheet, and the related customer
manual, thoroughly before using the tool holder
assembly.
2. DESCRIPTION
The tool holder assembly facilitates the connection of
the crimping head to the SDE Electric Bench Machine
and provides the necessary straight line motion of the
movable die when the SDE Electric Bench Machine is
actuated.
Figures and illustrations are for reference only,
and are not to scale.
NOTE
i
This instruction sheet provides:
The tool holder assembly features a switch (handle)
and three quick pins. See Figure 2. The switch
(handle) can be used to manually open and close the
dies of the crimping head for insertion and removal of
the product.
S Instructions for installing and removing the tool
holder assembly to the Electric Bench Machine
S Instructions for installing the crimping head
onto the tool holder assembly
The two outer quick--release pins secure the outer
tabs of the crimping head to the tool holder assembly,
and the center quick--release pin secures the the
movable die of the crimping head to the internal
spring--loaded switch of the tool holder assembly.
S Instructions for adjusting the crimp height
S Maintenance, inspection, and repair
instructions for the tool holder assembly
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
E2010 Tyco Electronics Corporation, Berwyn, PA
1 of 5
All Rights Reserved
TE logo and Tyco Electronics are trademarks.
LOC B
*Trademark. Other product names, logos, or company names might be trademarks of their respective owners.
5秒后页面跳转
AO3401场效应管参数、引脚图、应用原理图
BT131可控硅参数及引脚图、工作原理详解
74LS32芯片参数、引脚图及功能真值表
全球首块英伟达H200交付 黄仁勋“送货上门”
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
