Datasheet > 020-2944-XX

020-2944-XX

更新时间： 2022-02-26 12:16:50

品牌	Logo	应用领域
泰克 - TEKTRONIX		/
页数	文件大小	规格书
10页	516K
描述
P7600 Series TriModeâ¢ Probes

阅读下载

获取价格

数据手册

如果您发现信息不准确，欢迎纠错

020-2944-XX 数据手册

™

P7600 Series TriMode Probes

TekConnect Interface - TekConnect scope/probe control and usability

Direct control from probe compensation box or from scope menu

Applications

Including, but not limited to:

MIPI M-PHY, PCI Express, Serial ATA, Serial Attached SCSI, Fibre

Channel, and HDMI

Combining TriMode probing with low noise

performance

TriMode probing enhances productivity by enabling differential, single-

ended, and common mode measurements with a single probe setup.

Connecting a probe to the device under test can be a time consuming

activity, especially if the probe has to be set up differently to make all the

necessary measurements. TriMode probing improves productivity by

reducing setup time, because only one setup is needed to make the three

different types of measurements. Switching between Differential Mode [A-

B], Single-Ended Mode [A-Gnd, B-Gnd], and Common Mode [((A+B)/2)-

Gnd] is as easy as a press of a button.

P7633 Low Noise TriMode Probe

The P7600 Series TriMode probes and the MSO/DPO70000DX and DPO/

DSA70000D Series Oscilloscopes are designed to deliver the industry's

lowest system noise levels. This high sensitivity is critical for being able to

make accurate measurements on low amplitude signals.

Key performance specs

Full 33 GHz bandwidth to the probe tip (P7633)

Industry's lowest probe and oscilloscope system noise

Key features

™

TriMode probe - one setup, three measurements without adjusting

probe tip connections

Differential

Single ended

Changing input modes on the probe is as easy as a press of a button

Common mode

As high speed serial data standards increase in speed and signal swings

shrink, probes with high bandwidth coupled with low noise and high

sensitivity are increasingly important for making accurate measurements.

Remote head design connectivity

Allows placement of probe amplifier close to the circuit being

measured

Coaxial adapters

2.92mm

SMP

P7500 probe tip adapter

Use P7500 Series TriMode solder-in probe tips

Probe automatically detects tips and applies DSP correction filters

Probe-specific S-parameters

12 Gb/s 200 mV_ppsignal measured with a P7633 and a P76CA-292C coaxial adapter

Unique DSP filters created from data stored in the probe

www.tek.com

12 3 4 5 6 7...10

下载PDF

与020-2944-XX相关器件

型号	品牌	描述	获取价格	数据表
020-2954-XX	ETC	DDR Memory Bus Electrical Validation and Analysis Software	获取价格
020-2955-XX	ETC	DDR Memory Bus Electrical Validation and Analysis Software	获取价格
020-3%-FA3-90PPM-CARDPACK	VISHAY	Fixed Resistor, Wire Wound, 3W, 0.02ohm, 130V, 3% +/-Tol, -90,90ppm/Cel,	获取价格
0203.250	LITTELFUSE	可提供Flat-Pak?保险丝设计的快熔型和Slo-Blo?型号。这两种设计均采用鸥	获取价格
0203.250H	LITTELFUSE	Surface Mount Fuses FLAT-PAKÂ® Fast-Acting Fu	获取价格
0203.250HXG	LITTELFUSE	203 Series Fuse	获取价格